User manual ZONET ZFS3308E

[. . . ] Package Contents · · · · One ZFS3308E One Quick Installation Guide One Power Adapter Four Rubber Pads Contact your local authorized reseller or the store purchased from for any items damaged and/or missing. Application Front Panel LED PWR 1~8 Status Steady Steady Flash Operation Power is ON Network cable connected and connection established Data packets are transmitting Rear Panel Item Name DC 1~8 Description Power connector, connects to power adapter RJ-45 ports 1 to 8 Installation 1 Connect the provided power adapter to the Power connector of the ZFS3308E 2 Connect your network devices to the RJ-45 ports of the ZFS3308E with UTP/STP Category 3/4/5 cables Caution · The switch must put on a surface that is able to hold at least 5kgs weight · Power adapter must be connected to the switch properly and securely · Suggested at least 10cm empty space around the unit for sufficient ventilation and cooling · Do not recommend to put any items on top of the switch · ZFS3308E is not ideally to work in a high electromagnetic environment, under direct sunlight, dust and vibrating surfaces · Maximum distance between the switch and the end node is 100 meters · Must use an unshielded or shielded twisted-pair (UTP/STP) Category 5 or better cables to ensure proper transmission · Loss of data packet may encounter when using cable other than Category 5 Troubleshooting 1. [. . . ] Test your computer's network adapter to make sure it is installed and functioned properly. Check issues such as network collisions, domain limitations, and other physical installation aspects. Make sure they all meet IEEE standard network installation requirements, more details can be found at www. ieee. org. If problem still persists, write down your software/hardware configuration and LED error indications and contact your local retailer or the store purchased for further assistance. [. . . ] If the provided power adapter is missing, purchase 9V / 700mA power adapter for replacement. [. . . ]