User manual ZIBRO SRE910

[. . . ] EXTENSION Indicator lights SAVE key TIMER For each Zibro Kamin model the minimum size of space is specified in which you can use the heater safely, without additional ventilation (refer to Section P). If a particular room is smaller than the specified space, always leave a window or door slightly ajar (± 2. We also recommend doing this in highly insulated or draught-free rooms and/or at altitudes above 1, 500 metres. Only the use of the correct fuel will ensure safe, efficient, and comfortable use of your Zibro Kamin. [. . . ] The latter can be changed with the adjustment keys (refer to Section E). The temperature setting can only be adjusted, when the heater is burning. First press either of the two keys to MIN) to set switch on the function (the TEMP light next to the information display ¹ will start blinking). Next, adjust the temperature using the key on the right ( the temperature to a higher setting and the key on the left ( HOUR) to lower the temperature. After approximately 10 seconds the light will stop blinking and the setting will be locked (Fig. When the heater has been unplugged for more than 10 minutes (or after a power failure), the temperature will reset to the factory setting of 20°C. In order to switch on the timer, the correct time must have been set (refer to Section C) and the heater should be off. Follow the procedure below: 1 Press the ON/OFF button and then the TIMER key immediately after that. HOUR) to set the hours and the key on the right Use the key on the left ( 3 After approximately 10 seconds the information display will show CLOCK again and the TIMER indicator light will light up, indicating that the timer function has been activated (Fig. When you want to switch off the heater and ignite it again with the timer, all you have to do is press the TIMER key (refer to Section G). 2 Press the TIMER key , when you want to switch off the heater and ignite it Again with the timer the next time. This not only switches off the heater, but it also activates the timer function. You can change the required time with the adjustment keys (refer to Section F). The information display ¹ not only serves as an indicator of the (set) time and temperature (Sections C, E, and F), it also indicates any malfunctioning of the heater. H: In case of any malfunctioning the information display will tell you what is the matter. Always contact your Zibro Kamin dealer for any malfunctioning not listed above. When te heater has been burning continuously for two hours at its highest The procedure takes 5 minutes, during which the heater will burn at its lowest setting, while the burner autocleans. When the burner is clean again, the heater will automatically switch back to the highest setting again. The childproof lock can be used to prevent children accidentally changing the heater settings. When the heater is burning and the childproof lock is on, the heater can only be switched off. [. . . ] At the end of the heating season, you must store the heater in a dust-free place, if possible in its original packaging. If there is still some fuel left, do not throw it away, but dispose of it in accordance with the local regulations for the disposal of domestic chemical waste. When you start re-using the heater follow the instructions again (starting from section A and as specified). Take the following measures to avoid fuel leakage during the transportation of the heater: 1 Let the heater cool down. [. . . ]