User manual ZIBRO SRE270TC

[. . . ] Lower quality fuel may result in: increased possibility of malfunctioning incomplete burning Only the use of the correct fuel will ensure safe, efficient, and comfortable use of your heater. reduced heater lifetime smoke and/or smells deposits on the grid or mantle Using the right fuel is therefore essential for safe, efficient, and comfortable use of your heater. Always refer to your local dealer for the right fuel for your heater. A This transportation cap is packed separately in the box. Only this cap ensures trouble-free transportation of the heater after use. Store it well! 4 44 MANUAL A INSTALLING THE HEATER 1 Carefully remove your heater from the box and check the contents. In addition to the heater you also need to have: a manual fuel pump a transportation cap these directions for use Keep the box and the packaging materials (Fig. [. . . ] First press either of the two keys to switch on the function (the 4-digit will start blinking). When you hold down the key, the value will continue going up, until you release the key E: When the 4-digit stops blinking, the setting has been locked to the indicated value. again. After approximately 10 seconds the 4-digit will stop blinking and the setting will be locked. 5 minutes after switching off the heater, the information on the display will disappear and the heater will automatically switch into the standby position. D F: The required temperature on the left, the measured temperature on the right. When the heater has been unplugged (or after a power failure), the time needs to be set again. IGNITING THE HEATER When used for the first time, a new heater may give out a smell for a short while. The POWER lamp will start blinking, indicating that the ignition procedure has started. The light next to them indicates that these numbers refer to the temperatures (Fig. The actual room temperature is indicated below ROOM, while the temperature setting is indicated below SET. The latter can be changed with the adjustment keys (refer to Section E). Prior to igniting the heater, always check for sufficient fuel in the removable tank. E SETTING THE REQUIRED TEMPERATURE The temperature setting can only be adjusted, when the heater is burning. First press either of the two keys to min. ) to set the temperature to a switch on the function (the C mark and 4-digit will start blinking). Next, adjust the temperature using the key on the right ( 4 46 higher setting and the key on the left ( hour) to lower the temperature. The KEY-LOCK indicator Switch off the childproof lock by pressing the key than 3 seconds once again. will appear on the information display (Fig. and holding it down for more 4 48 J I: When the SAVE function is activated, the heater will automatically switch on or off in order to remain within a specified temperature range. THE CORRECT USE OF 'SAVE' The 'SAVE' function allows you to limit the temperature. When this function is activated, the heater will automatically switch off, when the room temperature exceeds the set temperature by 3C. Subsequently, when the room temperature has dropped again to the set temperature, the heater will automatically switch on again. Activate the 'SAVE' setting by pressing the appropriate again. Without the 'SAVE' setting your heater will maintain the set temperature by key. Switch off the function by pressing the SAVE key once K J: When the FUEL indicator has appeard, the information display will show the number of minutes of fuel left in the tank. approximation as well, by adjusting its heating capacity. 'SAVE' is an economy setting, which you can use when, for instance, you are not present in the room or to keep it frost-free. THE 'FUEL' INDICATOR When the FUEL indicator appears, there is enough fuel left for another 10 minutes of heater use. The count-down of the remaining heating time can be seen in the information display (Fig. Every two minutes an alarm signal is sounded, warning you to refill the removable tank. The FUEL indicator will blink, while four lines are blinking in the information display. [. . . ] Do not use the heater in the immediate surrounding of a bath, a shower or a swimmingpool. Unplug the heater as well, when you go away for a longer period of time (e. g. Make sure that the fuel is not exposed to heat or extreme temperature changes. Always store the fuel in a cool, dry and dark place (sunlight will affect the quality). [. . . ]