User manual ZIBRO SRE260

[. . . ] Connection Weektimer Indicator lights SAVE key TIMER For each model the minimum size of space is specified in which you can use the heater safely, without additional ventilation (refer to Section P). If a particular room is smaller than the specified space, always leave a window or door slightly ajar (± 2. We also recommend doing this in highly insulated or draught-free rooms and/or at altitudes above 1, 500 metres. Only the use of the correct fuel will ensure safe, efficient, and comfortable use of your Zibro. [. . . ] The light next to them indicates that these numbers refer to the temperatures (Fig. The actual room temperature is indicated below ROOM, while the temperature setting is indicated below SET. The latter can be changed with the adjustment keys (refer to Section E). The temperature setting can only be adjusted, when the heater is burning. ) to set switch on the function (the TEMP light next to the information display ¹ will start blinking). Next, adjust the temperature using the key on the right ( the temperature to a higher setting and the key on the left ( hour) to lower the After approximately 10 seconds the light will stop blinking and the setting will be locked (Fig. When the heater has been unplugged (or after a power failure), the temperature will reset to the factory setting of 20°C. In order to switch on the timer, the correct time must have been set (refer to Follow the procedure below: 1 Press the button and then the TIMER key immediately after that. 2 Use the adjustment keys Use the key on the left ( To set the time at which the heater must ignite. Hour) to set the hours and the key on the right 3 After approximately 10 seconds the information display will show CLOCK again and the TIMER indicator light will light up, indicating that the timer function has been activated (Fig. When you want to switch off the heater and ignite it again with the timer, all you have to do is press the TIMER key (refer to Section G). If you would like more extensive timer possibilities, we advise you to procure the Zibro weektimer. Without pressing the button, when you want 2 Press the TIMER key to switch off the heater and ignite it again with the timer the next time. This not only switches off the heater, but it also activates the timer function. As long as the TIMER light and the information display ¹ are blinking, you can change the required time with the adjustment keys (refer to Section F). The information display ¹ not only serves as an indicator of the (set) time and temperature (Sections C, E, and F), it also indicates any malfunctioning of the heater. In case of any malfunctioning the information display will tell you what is the matter. When te heater has been burning continuously for two hours at its highest The procedure takes 5 minutes, during which the heater will burn at its lowest setting, while the burner autocleans. When the burner is clean again, the heater will automatically switch back to the highest setting again. I: When the KEY-LOCK light lights up, the childproof lock has been activated. [. . . ] When the power cord is damaged, it may only be replaced by an authorised fitter. At the end of the heating season, you must store the heater in a dust-free place, if possible in its original packaging. If there is still some fuel left, do not throw it away, but dispose of it in accordance with the local regulations for the disposal of domestic chemical waste. When you start re-using the heater follow the instructions again (starting from section A and as specified). [. . . ]