User manual ZIBRO SRE187

[. . . ] Your Zibro Kamin heater has been designed for use with high-quality water-free pure paraffin oil, such as Zibro Plus. Lower quality fuel may result in: increased possibility of malfunctioning incomplete burning reduced heater lifetime smoke and/or smells deposits on the grid or mantle Using the right fuel is therefore essential for safe, efficient, and comfortable use of your heater. Always refer to your local Zibro Kamin dealer for the right fuel for your heater. This cover allows you to keep your hands clean when opening the fuel tank. [. . . ] When you hold down the key, the value will continue going up, until you release the key again. After approximately 10 seconds the blinking will stop and the setting will be locked. 5 minutes after switching off the heater, the information on the display will disappear and the heater will automatically switch into the stand-by position. F: When the CLOCK indicator light stops blinking, the setting has been locked to the indicated value. When the heater has been unplugged (or after a power failure), the time needs to be set again. When used for the first time, a new heater may give out a smell for a short while. Once the heater is burning, the information display ¹ will show two numbers. The light next to them indicates that these numbers refer to the temperatures (Fig. The actual room temperature is indicated below ROOM, while the temperature setting is indicated below SET. The latter can be changed with the adjustment keys (refer to Section E). The temperature setting can only be adjusted, when the heater is burning. The childproof lock can be used to prevent children accidentally changing the heater settings. When the heater is burning and the childproof lock is on, the heater can only be switched off. If the heater has already been switched off, the childproof lock also prevents accidental ignition of the heater. Activate the childproof lock by pressing the appropriate key and holding it down for more than 3 seconds. Switch off the childproof lock by pressing the key seconds once again. And holding it down for more than 3 I: When the KEY-LOCK light lights up, the childproof lock has been activated. When this function is activated, the heater will automatically switch off, when the room temperature exceeds the set temperature by 3°C. Subsequently, when the room temperature has dropped again to the set temperature, the heater will automatically switch on again. Without the 'SAVE' setting your heater will maintain the set temperature by J: When the SAVE light lights up, the heater will automatically switch on or off in order to remain within a specified temperature range. 'SAVE' is an economy setting, which you can use when, for instance, you are not present in the room or to keep it frost-free. When the FUEL indicator light lights up, there is enough fuel left for another 10 minutes of heater use. [. . . ] Within this period all defects in material or workmanship will be repaired without any charge. The following provisions shall apply regarding this warranty: 2 Any repairs or replacements of components within the term of warranty will not result in an extension of the term of warranty. 3 The warranty shall no longer apply, when the heater has been modified, non-original parts have been used, or when it is repaired by third parties. 4 The warranty shall not apply to parts that are subject to normal wear, such as the burner mat and the manual fuel pump. [. . . ]