User manual ZIBRO SRE186

[. . . ] Your Zibro Kamin heater has been designed for use with high-quality water-free pure paraffin oil, such as Zibro Plus. Lower quality fuel may result in: increased possibility of malfunctioning incomplete burning reduced heater lifetime smoke and/or smells deposits on the grid or mantle Using the right fuel is therefore essential for safe, efficient, and comfortable use of your heater. Always refer to your local Zibro Kamin dealer for the right fuel for your heater. A The fuel cap cover can be found at the rear of the heater. This cover allows you to keep your hands clean when opening the fuel tank. This transportation cap is packed separately in the box. [. . . ] After approximately 10 seconds the blinking will stop and the setting will be locked. 5 Minutes after switching off the heater, the information on the display will disappear and the heater will automatically switch into the stand-by position. 20 F: When the CLOCK indicator light stops blinking, the setting has been locked to the indicated value. + D SET ROOM TEMP CLOCK AVE TIMER When the heater has been unplugged for more than 10 minutes (or after a power failure), the time needs to be set again. IGNITING THE HEATER When used for the first time, a new heater may give out a smell for a short while. Always ignite the heater with the lighter. Just press the button button . Once the heater is burning, the information display will show two numbers. The light next to them indicates that these numbers refer to the temperatures (Fig. The actual room temperature is indicated below ROOM, while the temperature setting is indicated below SET. The latter can be changed with the adjustment keys (refer to Section E). Prior to igniting the heater, always check for sufficient fuel in the removable tank. 19:14 VENT G: The required temperature on the left, the measured temperature on the right. E SETTING THE REQUIRED TEMPERATURE The temperature setting can only be adjusted, when the heater is burning. First press either of the two keys to MIN) to set switch on the function (the TEMP light next to the information display will start blinking). Next, adjust the temperature using the key on the right ( the temperature to a higher setting and the key on the left ( HOUR) to lower the temperature. After approximately 10 seconds the light will stop blinking and the setting will be locked (Fig. Activate the childproof lock by pressing the appropriate key and holding it down for more than 3 seconds. Switch off the childproof lock by pressing the key seconds once again. and holding it down for more than 3 J 4 48 THE CORRECT USE OF 'SAVE' The 'SAVE' function allows you to limit the temperature. When this function is activated, the heater will automatically switch off, when the room temperature exceeds the set temperature by 3C. Subsequently, when the room temperature has TEMP CLOCK SAVE J: When the SAVE light lights up, the heater will automatically switch on or off in order to remain within a specified temperature range. dropped again to the set temperature, the heater will automatically switch on again. Activate the 'SAVE' setting by pressing the appropriate again. Without the 'SAVE' setting your heater will maintain the set temperature by approximation as well, by adjusting its heating capacity. Regularly inspect the fuel filter as well: Fuel filter N 1 Remove the removable tank from the heater and remove the fuel filter (Fig. 2 Remove the dirt by tapping the fuel filter upside-down against a hard surface. (Never clean it with water!) 3 Reinstall the fuel filter into the heater. We recommend that you remove dust and stains in time with a damp cloth, because otherwise these may cause stains that are hard to remove. 4 49 Do not remove any heater components yourself. [. . . ] Position the front of the heater at a distance of minimum 1. 5 metres from walls, curtains, and furniture. Do not use the heater in the immediate surrounding of a bath, a shower or a swimmingpool. Unplug the heater as well, when you go away for a longer period of time (e. g. Make sure that the fuel is not exposed to heat or extreme temperature changes. [. . . ]