User manual ZIBRO SRE177

[. . . ] Only this cap ensures trouble-free transportation of the heater after use. In addition to the heater you also need to have: a manual fuel pump a transportation cap these directions for use Keep the box and the packaging materials (Fig. Do not try to correct the situation by placing books or other goods under the heater. please refer to the separate instructions in the carton box for fixing of the heater. [. . . ] 5 minutes after switching off the heater, the information on the display will disappear and the heater will automatically switch into the stand-by position. When the heater has been unplugged (or after a power failure), the time needs to be set again. When used for the first time, a new heater may give out a smell for a short while. Once the heater is burning, the The light next to them indicates that these numbers refer to the temperatures (Fig. The actual room temperature is indicated below ROOM, while the temperature setting is indicated below SET. The latter can be changed with the adjustment keys (refer to Section E). The temperature setting can only be adjusted, when the heater is burning. ) to set switch on the function (the TEMP light next to the information display blinking). Next, adjust the temperature using the key on the right ( the temperature to a higher setting and the key on the left ( Seconds the light will stop blinking and the setting will be locked (Fig. When the heater has been unplugged (or after a power failure), the temperature will reset to the factory setting of 20°C. In order to switch on the timer, the correct time must have been set (refer to Section C) and the heater should be off. The count-down of the remaining heating time can be seen in the information display (Fig. Every two minutes an alarm signal is sounded, warning you to refill the removable tank. If you do not react, the heater will The heater will also sound a warning signal, when it switches The FUEL indicator light will blink, while four lines are blinking in the information display. Once the heater has used up all its fuel and is extinguished it will take some time, I: When the FUEL indicator light is lit, the information display will show the number of minutes of fuel left in the tank. After the refill, before the heater is completely ready for use again. When the VENT indicator light starts blinking, this is a sign that the room is not vented sufficiently (Fig. If the indicator light continues blinking after extra ventilation, please contact your dealer. Switch off the heater and let it cool down, before you start any maintenance work. It is, however, important that you clean the air filter ¾ and the vent filter µ with a vacuum cleaner and the grid with a damp cloth, both on a weekly basis. J: A blinking VENT indicator light is a sign that you need extra ventilation. We recommend that you remove dust and stains from time to time with a damp cloth, because otherwise these may cause stains that are hard to remove. [. . . ] 6 The warranty shall not apply to damages caused by actions not in compliance with the Directions for Use, neglect, and the use of an incorrect type of fuel, or fuel past its use-by date. 7 Transportation costs and the risks involved during the transportation of the heater or heater components shall always be at the expense of the purchaser. In order to avoid unnecessary costs, we recommend that you always read the 'Directions for Use' carefully first. In case they offer no solution, please take the heater to your dealer for repair. [. . . ]