User manual ZIBRO SRE176

[. . . ] Only this cap ensures trouble-free transportation of the heater after use. In addition to the heater you also need to have: a manual fuel pump a transportation cap these directions for use Keep the box and the packaging materials (Fig. Do not try to correct the situation by placing books or other goods under the heater. please refer to the separate instructions in the carton box for fixing of the heater. [. . . ] When used for the first time, a new heater may give out a smell for a short while. The light next to them indicates that these numbers refer to the temperatures (Fig. The actual room temperature is indicated below ROOM, while the temperature setting is indicated below SET. The latter can be changed with the adjustment keys (refer to Section E). The temperature setting can only be adjusted, when the heater is burning. ) to set the temperature to a switch on the function (the °C mark and 4-digit the temperature using the key on the right ( higher setting and the key on the left ( After approximately 10 seconds the °C mark When the heater has been unplugged (or after a power failure), the temperature will reset to the factory setting of 20°C. In order to switch on the timer, the correct time must have been set (refer to Section C) and the heater should be off. Follow the procedure below: 1 Press the button and then the TIMER key will start blinking. The TIMER light and the 4-digit 2 Use the adjustment keys Use the key on the left ( To set the time at which the heater must ignite. Hour) to set the hours and the key on the right 3 After approximately 10 seconds the 4-digit will show CLOCK again and the TIMER indicator light will light up, indicating that the timer function has been activated (Fig. When you want to switch off the heater and ignite it again with the timer, all you have to do is press the TIMER key (refer to Section G). J: When the FUEL indicator has appeard, the information display will show the number of minutes of fuel left in the tank. When the FUEL indicator appears, there is enough fuel left for another 10 minutes of heater use. The count-down of the remaining heating time can be seen in the information display (Fig. Every two minutes an alarm signal is sounded, warning you to refill the removable tank. The FUEL indicator will blink, while four lines are blinking in the information display. Once the heater has used up all its fuel and is extinguished it will take some time, after the refill, before the heater is completely ready for use again. When the VENT indicator starts blinking, this is a sign that the room is not vented sufficiently (Fig. If the indicator continues blinking after extra ventilation, please contact your dealer. K: A blinking VENT indicator is a sign that you need extra ventilation. Switch off the heater and let it cool down, before you start any maintenance work. It is, however, important that you clean the air filter ¾ and the vent With a damp cloth, both on a L) and clean it with soapy water. [. . . ] 4 The warranty shall not apply to parts that are subject to normal wear, such as the burner mat and the manual fuel pump. 5 The warranty shall only apply, when you present the original, dated proof of purchase, provided no changes have been made to it. 6 The warranty shall not apply to damages caused by actions not in compliance with the Directions for Use, neglect, and the use of an incorrect type of fuel, or fuel past its use-by date. 7 Transportation costs and the risks involved during the transportation of the heater or heater components shall always be at the expense of the purchaser. [. . . ]