User manual ZIBRO SRE173

[. . . ] If a particular room is smaller than the specified space, always leave a window or door slightly ajar (± 2. We also recommend doing this in highly insulated or draught-free rooms and/or at altitudes above 1, 500 metres. Only the use of the correct fuel will ensure safe, efficient, and comfortable use of your Zibro Kamin. Only use Class C1 paraffin fuel in accordance with BS2869: Part 2, or equivalent. [. . . ] The latter can be changed with the adjustment keys (refer to Section E). The temperature setting can only be adjusted, when the heater is burning. First press either of the two keys to switch on the function (the TEMP light next to the information display ¹ will start Next, adjust the temperature using the key on the right ( the temperature to a higher setting and the key on the left ( After approximately 10 seconds the light will stop blinking and the setting will be locked (Fig. When the heater has been unplugged for more than 10 minutes (or after a power failure), the temperature will reset to the factory setting of 20°C. In order to switch on the timer, the correct time must have been set (refer to Section C) and the heater should be off. Follow the procedure below: 1 Press the button and then the TIMER key immediately after that. 2 Use the adjustment keys Use the key on the left ( To set the time at which the heater must ignite. Hour) to set the hours and the key on the right Again and the TIMER indicator light will light up, indicating that the timer function has been activated (Fig. When you want to switch off the heater and ignite it again with the timer, all you have to do is press the TIMER key (refer to Section G). 2 Press the TIMER key , when you want to switch off the heater and ignite it Again with the timer the next time. This not only switches off the heater, but it also activates the timer function. You can change the required time with the adjustment keys (refer to Section F). The information display ¹ not only serves as an indicator of the (set) time and temperature (Sections C, E, and F), it also indicates any malfunctioning of the heater. The heater has been in operation continuously for a period of 49 hours and has turned itself off automatically. In case of any malfunctioning the information display will tell you what is the matter. Always contact your Zibro Kamin dealer for any malfunctioning not listed above. This heater is fitted with a safety system that ensures that it switches off automatically after 49 hours continuous operation. If desired, you can switch the heater on again by pressing (see chapter D). When te heater has been burning continuously for two hours at its highest setting, the burner will automatically start an autoclean procedure. the display will show the autocleaningcode cl:05 running back to cl:00. [. . . ] When the power cord is damaged, it may only be replaced by an authorised fitter. At the end of the heating season, you must store the heater in a dust-free place, if possible in its original packaging. If there is still some fuel left, do not throw it away, but dispose of it in accordance with the local regulations for the disposal of domestic chemical waste. Do not use the heater in dusty rooms or in places with strong draughts. [. . . ]