User manual ZIBRO SRE172E

[. . . ] SRE 172 E 3 2 6 5 4 > 1 MANUEL D'UTILISATION GEBRAUCHSANWEISUNG BRUGSANVISNING INSTRUCCIONES DE USO OPERATING MANUAL ISTRUZIONI D'USO GEBRUIKSAANWIJZING 2 12 22 32 42 52 62 3 PAGE PLIANTE FALTBLATT FOLDEUDSIDE HOJA DESPLEGABLE FOLD-OUT PAGE PIEGHEVOLE UITVOUWBLAD 2 6 5 4 > 1 a - EMC a - LV Dear Sir, Madam, Congratulations with your purchase of the Zibro, the number one brand among movable heaters. You have purchased a first-class quality product, which will serve you for many years to come. Please read these Directions for Use first, to ensure maximum lifetime for your Zibro. Your heater comes with a 24-month manufacturer's warranty on all defects in material or workmanship. We wish you much warmth and comfort with your Zibro. Yours sincerely, PVG International b. v. [. . . ] 2 Use the adjustment keys to set the time at which the heater must ignite. Use the key on the left (Nhour) to set the hours and the key on the right (Mmin. ) to set the minutes (interval of 5 minutes). timer save hour min. extension 3 After approximately 10 seconds the information display will show CLOCK again and the TIMER indicator light will light up, indicating that the timer function has been activated (Fig. 4 The timer will ensure that the room will have been heated to approximately temp. fuel 20:15 set room G: The TIMER indicator light indicates that the timer function has been switched on. the required temperature at the set time. G H When you want to switch off the heater and ignite it again with the timer, all you have to do is press the TIMER key (refer to Section G). Press the button once to clear the timer setting. SWITCHING OFF THE HEATER There are two ways to switch off the heater. 2 Press the TIMER key , when you want to switch off the heater and ignite it again with the timer the next time. This not only switches off the heater, but it also activates the timer function. You can change the required time with the adjustment keys (refer to Section F). THE INFORMATION DISPLAY The information display not only serves as an indicator of the (set) time and temperature (Sections C, E, and F), it also indicates any malfunctioning of the heater. The code on the information display tells you what is the matter: 4 47 save hour min. CODE extension INFORMATION Temperature within the heater too high. The heater has been in operation continuously for a period of 49 hours and has turned itself off automatically. fuel fPower interrupted. efeeee1 1 2 5 6 7 e- 0 In case of any malfunctioning the information display will tell you what is the matter. e- 8 e- 9 --blinking : -(& FUEL-light) Out of fuel. Too little ventilation. save hour -- : min. -e-11 (& blinking VENT-light) extension (& blinking VENT-light) . timer Always contact your Zibro dealer for any malfunctioning not listed above. Activate the 'SAVE' setting by pressing the appropriate key. Without the 'SAVE' setting your heater will maintain the set temperature by temp. clock timer save vent fuel 20:15 set room I: When the SAVE light lights up, the heater will automatically switch on or off in order to remain within a specified temperature range. approximation as well, by adjusting its heating capacity. 'SAVE' is an economy setting, which you can use when, for instance, you are not present in the room or to keep it frost-free. er save hour min. extension temp. fuel K THE 'FUEL' INDICATOR LIGHT When the indicator light FUEL lights up, it means that there is only fuel left for 10 more minutes. The count-down of the remaining heating time can be seen in the information display (Fig. Now you have two options: you remove the fuel tank and refill it outside the living room (section B) or you push the button EXTENSION . By pushing this button, the remaining heating time will extend to 50 minutes. At the arrival of 10, you will hear an alarm signal every two minutes, warning you to refill the removable tank. The fuel indicator light will blink, while four lines (--:--) are blinking in the information display. [. . . ] 4 The warranty shall not apply to parts that are subject to normal wear, such as the burner mat and the manual fuel pump. 5 The warranty shall only apply, when you present the original, dated proof of purchase, provided no changes have been made to it. 6 The warranty shall not apply to damages caused by actions not in compliance with the Directions for Use, neglect, and the use of an incorrect type of fuel, or fuel past its use-by date. 7 Transportation costs and the risks involved during the transportation of the heater or heater components shall always be for the account of the purchaser. [. . . ]