User manual ZIBRO SRE170TC

[. . . ] Do not use your heater in cellars or other underground areas. THE RIGHT FUEL Only the use of the correct fuel will ensure safe, efficient, and comfortable use of your Zibro. Only use Class C1 paraffin fuel in accordance with BS2869: Part 2, or equivalent. Your Zibro heater has been designed for use with high-quality water-free pure paraffin oil, such as Zibro Extra or Zibro Kristal. Lower quality fuel may result in: increased possibility of malfunctioning incomplete burning reduced heater lifetime smoke and/or smells deposits on the grid or mantle Using the right fuel is therefore essential for safe, efficient, and comfortable use of your heater. Always refer to your local Zibro dealer for the right fuel for your heater. A The fuel cap cover can be found at the rear of the heater. [. . . ] Follow the procedure below: 1 Press the button and then the TIMER key immediately after that. The TIMER light and the information display will start blinking. 2 Use the adjustment keys Use the key on the left ( to set the time at which the heater must ignite. hour) to set the hours and the key on the right ( min. ) to set the minutes (interval of 5 minutes). 3 After approximately 10 seconds the information display will show CLOCK again and the TIMER indicator light will light up, indicating that the timer function has been activated (Fig. 4 The timer will ensure that the room will have been heated to approximately the required temperature at the set time. H: The TIMER indicator light indicates that the timer function has been switched on. G H When you want to switch off the heater and ignite it again with the timer, all you have to do is press the TIMER key (refer to Section G). Press the button once to clear the timer setting. If you would like more extensive timer possibilities, we advise you to procure the Zibro weektimer. This timer is easy to connect with your Zibro Heater, see . SWITCHING OFF THE HEATER There are two ways to switch off the heater. 2 Press the TIMER key , when you want to switch off the heater and ignite it again with the timer the next time. This not only switches off the heater, but it also activates the timer function. You can change the required time with the adjustment keys (refer to Section F). E- 0 THE INFORMATION DISPLAY The information display not only serves as an indicator of the (set) time and temperature (Sections C, E, and F), it also indicates any malfunctioning of the heater. The code on the information display tells you what is the matter: CODE INFORMATION Temperature within the heater too high. WHAT TO DO Cool-down and re-ignite. In case of any malfunctioning the information display will tell you what is the matter. e- 0 4 47 fefeeee- 0 1 1 2 5 6 7 Power interrupted. The heater has been in operation continuously for a period of 65 hours and has turned itself off automatically. Re-ignite the heater. Clean filter Contact your dealer. e- 8 e- 9 Switch the heater back on. Ventilate better. --blinking : -(& FUEL-light) Out of fuel. Too little ventilation. --blinking : -(& VENT-light) Always contact your Zibro dealer for any malfunctioning not listed above. 65 H AUTOMATIC DEACTIVATION This heater is fitted with a safety system that ensures that it switches off automatically after 65 hours continuous operation. If desired, you can switch the heater on again by pressing (see section D). AUTOMATIC CLEANING MODE CL 05 When the heater has been burning continuously for two hours at its highest setting, the burner will automatically start an autoclean procedure. The count-down of the remaining heating time can be seen in the information display (Fig. Now you have two options: you remove the fuel tank and refill it outside the living room (section B) or you push the button EXTENSION . By pushing this button, the remaining heating time will extend to 60 minutes. The heater will automatically switch K: When the FUEL indicator light is lit, the information display will show the number of minutes of fuel left in the tank. back to its lowest position. At the arrival of 10, you will hear an alarmsignal every two minutes, warning you to refill the removable tank. THE 'VENT' INDICATOR LIGHT When the VENT indicator light starts blinking, this is a sign that the room is not vented sufficiently (Fig. [. . . ] Always store the fuel in a cool, dry and dark place (sunlight will affect the quality). Never use the heater in places where harmful gasses or fumes may be present (e. g. Always make sure that there is sufficient ventilation. Defective electrical devices and batteries must be kept separate from household waste. Ask you local council or dealer for expert advice on recycling. 4 51 DISTRIBUTED IN EUROPE BY PVG INTERNATIONAL BV i STERREICH PVG Austria VertriebsgmbH Salaberg 49 3350 HAAG tel: +43 7434 44867 +43 7434 44868 fax: email: pvgaustria@zibro. com e BELGI PVG Belgium NV/SA Industrielaan 55 2900 SCHOTEN tel: +32 3 326 39 39 +32 3 326 26 39 fax: email: pvgbelgium@zibro. com q SCHWEIZ PVG Schweiz AG Genuastrasse 15 4142 MNCHENSTEIN tel: +41 61 337 26 51 fax: +41 61 337 26 78 email: pvgint@zibro. com 2 DEUTSCHLAND PVG Deutschland GmbH Beiersdorfstrae 4 46446 EMMERICH tel: +49 2821 76713 fax: +31 412 622 893 email: pvgint@zibro. com 6 DANMARK PVG Scandinavia A/S Niels Bohrsvej 10 6100 HADERSLEV +45 73 53 02 02 tel: fax: +45 73 53 02 04 email: pvgdenmark@zibro. com 5 ESPAA PVG Espaa S. A. [. . . ]