User manual ZIBRO SRE166

[. . . ] Always refer to your local dealer for the right fuel for your heater. A This transportation cap is packed separately in the box. Only this cap ensures trouble-free transportation of the heater after use. Store it well! 4 44 MANUAL A INSTALLING THE HEATER 1 Carefully remove your heater from the box and check the contents. In addition to the heater you also need to have: a manual fuel pump a transportation cap these directions for use Keep the box and the packaging materials (Fig. [. . . ] When you hold down the key, the value will continue going up, until you release the key again. After approximately 10 seconds the 4-digit will stop blinking and the E: When the 4-digit stops blinking, the setting has been locked to the indicated value. setting will be locked. 5 minutes after switching off the heater, the information on the display will disappear and the heater will automatically switch into the standby position. D F: The required temperature on the left, the measured temperature on the right. When the heater has been unplugged (or after a power failure), the time needs to be set again. IGNITING THE HEATER When used for the first time, a new heater may give out a smell for a short while. The information display Just press the indicating that the ignition procedure has started. The light next to them indicates that these numbers refer to the temperatures (Fig. The actual room temperature is indicated below ROOM, while the temperature setting is indicated below SET. The latter can be changed with the adjustment keys (refer to Section E). Prior to igniting the heater, always check for sufficient fuel in the removable tank. E SETTING THE REQUIRED TEMPERATURE The temperature setting can only be adjusted, when the heater is burning. Next, adjust min. ) to set the temperature to a switch on the function (the C mark and 4-digit the temperature using the key on the right ( higher setting and the key on the left ( hour) to lower the temperature. After approximately 10 seconds the C mark 4 46 and 4-digit will stop blinking and the setting will be locked (Fig. F). The available temperature settings range from 6C minimum to 28C maximum. The KEY-LOCK indicator ( Switch off the childproof lock by pressing the key than 3 seconds once again. ) will appear on the H: When the mark appears, the childproof lock has been activated. information display (Fig. and holding it down for more J I: When the SAVE function is activated, the heater will automatically switch on or off in order to remain within a specified temperature range. THE CORRECT USE OF 'SAVE' The "SAVE" function allows you to limit the temperature. When this function is activated, the heater will automatically switch off, when the room temperature exceeds the set temperature by 3C. Subsequently, when the room temperature has dropped again to the set temperature, the heater will automatically switch on again. Activate the 'SAVE' setting by pressing the appropriate key. OFF will display 3 seconds on the information display. 4 48 Without the 'SAVE' setting your heater will maintain the set temperature by approximation as well, by adjusting its heating capacity. 'SAVE' is an economy setting, which you can use when, for instance, you are not present in the room or to keep it frost-free. K J: When the FUEL indicator has appeard, the information display will show the number of minutes of fuel left in the tank. THE 'FUEL' INDICATOR When the FUEL indicator appears, there is enough fuel left for another 10 minutes of heater use. The count-down of the remaining heating time can be seen in the information display (Fig. Every two minutes an alarm signal is sounded, warning you to refill the removable tank. If there is still some fuel left, do not throw it away, but dispose of it in accordance with the local regulations for the disposal of domestic chemical waste. [. . . ] Position the front of the heater at a distance of minimum 1. 5 metres from walls, curtains, and furniture. Do not use the heater in the immediate surrounding of a bath, a shower or a swimmingpool. Unplug the heater as well, when you go away for a longer period of time (e. g. Make sure that the fuel is not exposed to heat or extreme temperature changes. [. . . ]