User manual ZIBRO SRE158E

[. . . ] Note: To avoid unexpected shut off, we recommend to put a door or window ajar when the heater is operating. For each Zibro model the minimum size of space is specified in which you can use the heater safely, without additional ventilation (refer to Section P). If a particular room is smaller than the specified space, always leave a window or door slightly ajar (± 2. We also recommend doing this in highly insulated or draught-free rooms and/or at altitudes above 1, 500 metres. [. . . ] ) to set the temperature to a switch on the function (the °C mark and 4-digit the temperature using the key on the right ( higher setting and the key on the left ( After approximately 10 seconds the °C mark When the heater has been unplugged (or after a power failure), the temperature will reset to the factory setting of 20°C. In order to switch on the timer, the correct time must have been set (refer to Section C) and the heater should be off. Follow the procedure below: 1 Press the button and then the TIMER key will start blinking. The TIMER light and the 4-digit 2 Use the adjustment keys Use the key on the left ( To set the time at which the heater must ignite. Hour) to set the hours and the key on the right 3 After approximately 10 seconds the 4-digit will show CLOCK again and the TIMER indicator light will light up, indicating that the timer function has been activated (Fig. When you want to switch off the heater and ignite it again with the timer, all you have to do is press the TIMER key (refer to Section G). 2 Press the TIMER key , when you want to switch off the heater and ignite it Again with the timer the next time. This not only switches off the heater, but it also activates the timer function. You can change the required time with the adjustment keys (refer to Section F). The information display not only serves as an indicator of the (set) time and temperature (sections C, E, and F), it also indicates any malfunctioning of the heater. In case of any malfunctioning the information display will tell you what is the matter. The heater has been in operation continuously for a period of 65 hours and has turned itself off automatically. This heater is fitted with a safety system that ensures that it switches off automatically after 65 hours continuous operation. If desired, you can switch the heater on again by pressing (see section D). When the heater has been burning continuously for two hours at its highest setting, the burner will automatically start an autoclean procedure. the display will show the autocleaningcode cl 05 running back to cl 00. The procedure takes 5 minutes, during which the heater will burn at its lowest setting, while the burner autocleans. When the burner is clean again, the heater will automatically switch back to the highest setting again. The childproof lock can be used to prevent children accidentally changing the heater settings. When the heater is burning and the childproof lock is on, the heater can only be switched off. [. . . ] When the power cord is damaged, it may only be replaced by an authorised fitter. At the end of the heating season, you must store the heater in a dust-free place, if possible in its original packaging. If there is still some fuel left, do not throw it away, but dispose of it in accordance with the local regulations for the disposal of domestic chemical waste. Do not use the heater in the immediate surrounding of a bath, a shower or a swimmingpool. [. . . ]