User manual ZIBRO SRE156

[. . . ] Connection weektimer Indicator lights SAVE key TIMER 4 43 WHAT YOU NEED TO KNOW IN ADVANCE ALWAYS MAKE SURE THAT THERE IS SUFFICIENT VENTILATION For each Zibro Kamin model the minimum size of space is specified in which you can use the heater safely, without additional ventilation (refer to Section P). If a particular room is smaller than the specified space, always leave a window or door slightly ajar ( 2. 5 cm). We also recommend doing this in highly insulated or draught-free rooms and/or at altitudes above 1, 500 metres. Do not use your Zibro Kamin in cellars or other underground areas. THE RIGHT FUEL Only the use of the correct fuel will ensure safe, efficient, and comfortable use of your Zibro Kamin. Only use Class C1 paraffin fuel in accordance with BS2869: Part 2, or equivalent. [. . . ] After approximately 10 seconds the light will stop blinking and the setting will be locked (Fig. G). 4 46 The available temperature settings range from 6C minimum to 28C maximum. When the heater has been unplugged for more than 10 minutes (or after a power failure), the temperature will reset to the factory setting of 20C. F USING THE TIMER The timer allows you to switch on the heater automatically at a preset time. In order to switch on the timer, the correct time must have been set (refer to Section C) and the heater should be off. Follow the procedure below: 1 Press the button and then the TIMER key immediately after that. The TIMER light and the information display will start blinking. 2 Use the adjustment keys Use the key on the left ( to set the time at which the heater must ignite. HOUR) to set the hours and the key on the right ( MIN) to set the minutes (interval of 5 minutes). TEMP CLOCK SAVE TIMER 20 3 After approximately 10 seconds the information display will show CLOCK again and the TIMER indicator light will light up, indicating that the timer function has been activated (Fig. 4 The timer will ensure that the room will have been heated to approximately the required temperature at the set time. When you want to switch off the heater and ignite it again with the timer, all you have to do is press the TIMER key (refer to Section G). Press the button once to clear the timer setting. H: The TIMER indicator light indicates that the timer function has been switched on. + + G H If you would like more extensive timerpossibilities, we advise you to procure the Zibro Kamin weektimer. (available from 2003). SWITCHING OFF THE HEATER There are two ways to switch off the heater. 2 Press the TIMER key , when you want to switch off the heater and ignite it again with the timer the next time. This not only switches off the heater, but it also activates the timer function. You can change the required time with the adjustment keys (refer to Section F). THE INFORMATION DISPLAY The information display not only serves as an indicator of the (set) time and temperature (Sections C, E, and F), it also indicates any malfunctioning of the heater. The code on the information display tells you what is the matter: 4 47 CODE INFORMATION Temperature within the heater too high. The heater has been in operation continuously for a period of 65 hours and has turned itself off automatically. Refill removable tank. SET ROOM e-: 0 TIMER VENT In case of any malfunctioning the information display will tell you what is the matter. efefeeee- 0 0 1 1 2 5 6 7 e- 8 e- 9 -- : -- (& blinking FUEL-light) Switch the heater back on. Ventilate better. --blinking : -(& VENT-light) Always contact your Zibro Kamin dealer for any malfunctioning not listed above. SET ROOM AUTOMATIC DEACTIVATION This heater is fitted with a safety system that ensures that it switches off automatically after 65 hours continuous operation. Switch off the function by pressing the SAVE key once + K L M THE 'FUEL' INDICATOR LIGHT When the FUEL indicator light lights up, there is enough fuel left for another 10 minutes of heater use. The count-down of the remaining heating time can be seen in the information display (Fig. Every two minutes an alarm signal is SET ROOM 20:10 TIMER VENT FUEL K: When the FUEL indicator light is lit, the information display will show the number of minutes of fuel left in the tank. sounded, warning you to refill the removable tank. The FUEL indicator light will blink, while four lines are blinking in the information display. Once the heater has used up all its fuel and extinguished, it will take some time, after the refill, before the heater is completely ready for use again. SET ROOM 20:15 TIMER VENT L: A blinking VENT indicator light is a sign that you need extra ventilation. THE 'VENT' INDICATOR LIGHT When the VENT indicator light starts blinking, this is a sign that the room is not vented sufficiently (Fig. [. . . ] Always store the fuel in a cool, dry and dark place (sunlight will affect the quality). Never use the heater in places where harmful gasses or fumes may be present (e. g. Always make sure that there is sufficient ventilation. 5 6 7 8 9 10 4 51 AFNOR CERTIFICATION 11, AVENUE FRANCIS DE PRESSENSE 93571 SAINT-DENIS LA PLAINE CEDEX FICHE INFORMATIVE La marque NF garantit la qualit de cet article suivant les normes franaises et Rglement de certification de l'application NF 128 CHAUFFAGES MOBILES A COMBUSTIBLE LIQUIDE NF 128 02 / 02 CONFORME A LA NORME NF D 35-300 ET AUX SPECIFICATIONS COMPLEMENTAIRES DEFINIES PAR LE REGLEMENT PARTICULIER DE LA MARQUE NF 128 PRINCIPALES CARACTERISTIQUES CERTIFIEES: Scurit du dispositif d'allumage Dbit calorifique Efficacit des dispositifs de scurit Stabilit Contrle de la teneur en NOx dans les produits de combustion Contrle de la qualit de la combustion (absence de CO) Endurance Intermittence CONSEILS D'UTILISATION ET D'ENTRETIEN Se reporter la notice jointe l'appareil et la plaque de scurit sur l'appareil. Rfrence et numro de lot ou de srie de l'article : se reporter au produit Distributed in Europe by: PVG International B. V. P. O. Box 96, 5340 AB OSS Pays-Bas Tl. : +31 (0) 412 694670 En cas d'insatisfaction, consultez d'abord : En France: PVG France SARL 4, Rue Jean Siblius, B. P. 185 76410 SOTTEVILLE SOUS LE VAL Tl. : 02. 32. 96. 07. 47 Fax: 02. 32. 96. 07. 77 Si une difficult subsistait, vous pouvez crire au LNE LABORATOIRE NATIONAL D'ESSAIS Service Certification et Conformit Technique 1, Rue Gaston Boisier - 75724 PARIS CEDEX 15 set room temp. [. . . ]