User manual ZIBRO S185

[. . . ] It is detrimental to your health to remain in the cold airstream for an extended period of time. We recommend that you allow the airstream to flow freely into the room, without obstruction. If a fault occurs, switch the machine off with the remote control before pulling the plug out of the socket. This must be fitted by a recognised installer in accordance with local regulations and ordinances. [. . . ] After the indoor and outdoor units have been connected, air and moisture must be removed with the aid of a vacuum pump (see below). Allow the vacuum pump to operate for 10-15 minutes until a pressure of 10 mmHg absolute is achieved. Close the low-pressure button on the vacuum pump while the pump is still operating. Open the two-way valve (1/4 turn), and close it again after 10 seconds. check all connections with liquid soap or an electronic leak detector. make sure that no air remains in the cooling system and that no refrigerant is leaking. Testing: switch the air conditioner on after installation and take notes on the operation. The plug must be easily accessible in order to be able to switch the unit off in case of emergency. If there is no easy access, a bipolar main switch must be installed at an easily accessible location. EMERGENCY BUTTON To operate the unit if the remote control is not operational. EMERGENCY BUTTON To operate the unit if the remote control is not operational. Following a power cut, the machine will resume operation in the last selected function. The shapes and positions of the switches and indicators may differ for each model. DOWN button (TOO WARM button) To lower the preset room temperature and reduce time periods. UP button (TOO COLD button) To raise your preset room temperature and extend time periods. Place the new batteries as indicated (ensure that the positive (+) and negative poles (-) are in the correct positions. Replace the batteries with new batteries of the same type (see above) when the display starts to fade. The air conditioner can be operated in this manner up to a distance of 7 metres. The operating mode is selected automatically (HEATING, DRY, FAN, COOLING), depending on the room temperature at the time the selection takes place. The RUN indicator on the indoor unit will light up when the machine receives a signal. Indoor temperature Less than 20 °C More than 26 °C 20 ­ 26 °C Operating mode DRY Desired temperature 18 °C 23 °C 23 °C The indicator will not change after the temperature has been increased by 2°C. The indicator will not change after the temperature has been lowered by 2°C. [. . . ] Components subject to normal wear, such as the filter, are not covered by the guarantee. the guarantee is valid exclusively when you present the original , dated and unaltered purchase invoice. The guarantee does not cover damage caused by actions that deviate from the instructions for use or neglect. Shipment costs and the risks associated with shipping the air conditioner or parts thereof will always be borne by the buyer. [. . . ]