User manual ZENEC ZEM-W701RM

[. . . ] You can easily discover ZENEC Navigation Software while you are using it; however, we still recommend that you read this manual to understand the screens and the features of ZENEC Navigation Software. ZENEC Navigation Software is a navigation system that helps you find your way to your destination with its built-in GPS receiver. ZENEC Navigation Software does not transmit your GPS position; others cannot track you. It is important that you look at the display only when it is safe to do so. [. . . ] To run the simulation at normal speed and with voice guidance instructions , . The simulation can be aborted any time by tapping You do not need to pause the active route: when you start driving again, ZENEC Navigation Software restarts the voice instructions from your position. 7 Deleting the next via point from the route The easiest way to delete the upcoming route point (the next via point) is to open the Route Information screen by tapping the Turn Preview field () on the Map screen, and then tapping . The easiest way to delete the active route is to open the Route Information screen by tapping the Turn Preview field () on the Map screen, and then tapping You have another option. If via points exist in the active route, you cannot delete the route immediately on the Route Information screen. Enter a name for the saved route, and then tap When you save a route, ZENEC Navigation Software not only saves the route points but the whole itinerary: The saved route might have been influenced by TMC information. But if it needs to be recalculated, the current TMC information will be used in the new route. If you updated your map since you first saved the route, ZENEC Navigation Software recognises the change, and recalculates the driving instructions according to the latest available map information. ZENEC Navigation Software deletes from the route any via points that you already left behind during navigation together with the road segments used to reach it. To avoid this, if you want to save the route, you need to save it before you start navigating. In the very likely case when the start position of the saved route is different from the current GPS position, you need to confirm whether you want to stop navigating from the current GPS position to use the start point of the loaded route. The same symbols are used in both fields: The number of the exit is shown in the circle, but only for the next turn. In certain situations when route events are not important, these fields show other useful pieces of information. ZENEC Navigation Software shows the streets in a way that is similar to how the paper road maps show them. Their width and colours correspond to their importance: you can easily tell a motorway from a small street. If you prefer not to see street names during navigation, turn them off (page 62). To enable or disable 3D visualisation on the map, tap the following buttons: , . Landmarks are 3D artistic or block representations of prominent or well-known objects. Hills and mountains are shown in the background of the 3D map view, and illustrated by colour on the 2D map. complex intersections and vertically isolated roads (such as overpasses or underground tunnels) are displayed in 3D. Full 3D city building data that represents actual building size and position on the map. building data is limited to the city centres of major cities in the US and Europe. [. . . ] However, if the Software Product operates after installation without the use of the original media copy, then the original media copy shall be deemed to be a backup copy. In all other cases, the User is only entitled to use the backup copy if the original media copy of the Software Product has been ascertainably and unequivocally rendered unsuitable for its lawful and intended use. 2 to lease, rent or lend it or to transfer it to a third person for any reason; 7. 5 to evade the protection of the Software Product or to modify, circumvent or obviate such protection through technological or by any other means; 7. [. . . ]