User manual ZANUSSI ZWI1125

[. . . ] User Manual Washing machine Centrifugeren Centrifugeren Pompen Spoelen Inweken Inweken 30° Gordijnen Gordijnen 40° Sport Spor t 40° intensief Wol 40° Handwas Handwas 30° Handwas Handwas 40° 95° Startuitstel Star tuitstel 60° eco 60° 40° 30° 60° 40° 1300 900 700 500 Spoelstop Centrifugeren Centrifugeren Extra kort kor t Opties Voorwas oorwas 3u 6u 9u Hoofdwas Hoofdwas Spoelen/ Centrifugeren Centrifugeren Einde Extra spoelen Start auze Star t/Pauze 30° 30° Anti-kreuk 40° 40° Anti-kreuk ZWI 1125 Thank you for selecting our appliance We wish you lots of enjoyment with your new appliance and we hope that you will consider our brand again when purchasing household appliances. Please read this user manual carefully and keep it throughout the product life cycle as a reference document. The user manual should be passed on to any future owner of the appliance. The following symbols are used in this manual: Important information concerning your personal safety and information on how to avoid damaging the appliance. General information and tips Environmental information Content Safety information - - - - - - - - - - - - - - - - - - -3 Description of the appliance - - - - - - - - - - - -5 Detergent dispenser drawer - - - - - - - - - - - -5 Control panel and functions - - - - - - - - - - - -6 Programme table - - - - - - - - - - - - - - - - - -8-9 Washing Hints - - - - - - - - - - - - - - - - - - - - -10 Before the first use - - - - - - - - - - - - - - - - -12 Operating Sequence - - - - - - - - - - - - - - - -13 Care and cleaning - - - - - - - - - - - - - - - - - -16 What to do if. . . [. . . ] If you need to open the door, you must first set the washing machine to PAUSE by pressing the button 5 and wait few minutes before opening the door. The Delay Start cannot be selected with DRAIN programme. 14 At the end of the programme The machine stops automatically. The pilot light of button 5 goes off while the phase light C illuminates. If at the end of a programme there is water in the tub, to empty out the water follow the following instructions: turn the programme selector dial to «O» select the DRAIN or SPIN programme reduce the spin speed if needed, by means of the relevant button press button 5 At the end of the cycle, turn the programme selector dial to «O» to switch the machine off. Remove the laundry from the drum and carefully check that the drum is empty. Leave the door open to prevent the formation of mildew and unpleasant smells. 15 Care and cleaning IMPORTANT!You must DISCONNECT the appliance from the electricity supply, before you can carry out any cleaning or maintenance work. It is a good idea to periodically use a water softening powder in the machine. Do this separately from any laundry washing, and according to the softening powder manufacturer's instructions. Maintenance Wash With the use of low temperature washes it is possible to get a build up of residues inside the drum. Use a normal measure of detergent, must be a powder with biological properties. External cleaning Clean the exterior cabinet of the appliance with soap and water only, and then dry thoroughly. Cleaning the dispenser drawer The washing powder and additive dispenser drawer should be cleaned regularly. Remove the drawer by pressing the catch downwards and by pulling it out. Cleaning the drawer recess Having removed the drawer, use a small brush to clean the recess, ensuring that all washing powder residue is removed from the upper and lower part of the recess. Replace the drawer and run the rinse programme without any clothes in the drum. To aid cleaning, the top part of the additive compartment should be removed. 16 Cleaning the pump The pump should be inspected if the machine does not empty and/or spin the machine makes an unusual noise during draining due to objects such as safety pins, coins etc. B Pull out the emergency emptying hose (B), place it in the container and remove its cap. Always keep a rag nearby to dry up spillage of water when removing the cover. Remove any objects from the pump impeller by rotating it. Put the cap back on the emergency emptying hose and place the latter back in its seat. The dangers of freezing If the machine is exposed to temperatures below 0°C, certain precautions should be taken. Place the end of the emergency emptying hose and that of the inlet hose in a bowl placed on the floor and let water drain out. Screw the water inlet hose back on and reposition the emergency emptying hose after having put the cap on again. [. . . ] To align the door perfectly it is necessary to loosen the screw (3-Fig. d) Counter-magnet (6) The appliance is pre-arranged for a magnetic closure of the door. To enable a correct operation of this device, it is necessary to screw the counter-magnet (6) (steel disk + rubber ring) into the inner side of the door. Its position must correspond to the magnet (4) on the appliance (see picture D). 416 818 1 1 2 7 3 5 B 23 8 a) Door The dimensions of the door should be: - width 595-598 mm - thickness 16-22 mm The height (C-Fig. [. . . ]