User manual ZANUSSI ZWC85050W

[. . . ] User Manual Washing machine ZWC 85050 W Thank you for selecting our appliance We wish you lots of enjoyment with your new appliance and we hope that you will consider our brand again when purchasing household appliances. Please read this user manual carefully and keep it throughout the product life cycle as a reference document. The user manual should be passed on to any future owner of the appliance. The following symbols are used in this manual: Important information concerning your personal safety and information on how to avoid damaging the appliance. General information and tips Environmental information Content Safety information - - - - - - - - - - - - - - - - - - -3 Description of the appliance - - - - - - - - - - - -5 Detergent dispenser drawer - - - - - - - - - - - -5 Control panel - - - - - - - - - - - - - - - - - - - - - -6 Display - - - - - - - - - - - - - - - - - - - - - - - - - - -7 Functions - - - - - - - - - - - - - - - - - - - - - - - - -8 Programme table - - - - - - - - - - - - - - - - - -10 Programme information - - - - - - - - - - - - - -12 Washing Hints - - - - - - - - - - - - - - - - - - - - -13 Before the first use - - - - - - - - - - - - - - - - -15 Operating Sequence - - - - - - - - - - - - - - - -16 Care and cleaning - - - - - - - - - - - - - - - - - -19 Something not working - - - - - - - - - - - - - - 21 Technical data- - - - - - - - - - - - - - - - - - - - - 24 Consumption values - - - - - - - - - - - - - - - - 24 Installation instruction - - - - - - - - - - - - - - - 25 Environmental concerns - - - - - - - - - - - - - 28 2 Safety information In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. [. . . ] after pressing the button 8: it will be impossible to change any other programme or option. 15 Operating sequence 1. Load the laundry Open the door by carefully pulling the door handle outwards. Place the laundry in the drum, one item at a time, shaking them out as much as possible. If you turn the programme selector dial to another programme when the machine is working, the red pilot light of button 8 will blink 3 times and the message Err is displayed on the display to indicate a wrong selection. Select the temperature by pressing button 2 Press this button repeatedly to increase or decrease the temperature, if you want your laundry to be washed at a temperature different from the one proposed by the washing machine. The relevant light will light up For the maximum and minimum temperature provided for each programme, refer to the section «Programme table». Select the spin speed the Rinse Hold option by pressing button 3 The relevant light will light up. When selecting a programme, the light corresponding to the maximum speed allowed for that programme will illuminate. Select the desired option by means of buttons 4, 5 and 10Depending on the programme, different functions can be combined. These must be selected after choosing the desired programme and before depressing the button 8. For the compatibility of the options with the washing programmes, refer to the section «Programmes table». If an option which is not compatible with the set wash programme is selected, the message Err is displayed for few seconds and the red light of this button flashes for 3 times. Pull out the dispenser drawer until it stops. Measure out the amount of detergent required, pour it into the main wash compartment and, if you wish to carry out a programme with the prewash phase, pour it into the compartment marked . If required, pour fabric softener into the compartment marked (the amount used must not exceed the «MAX» mark in the drawer). Select the required programme by means of the programme selector dial (1) Turn the programme selector dial to the required programme. The green light of button 8 starts blinking. It can be turned either clockwise or anticlockwise. On position «O» the programme is reset and the machine is switched OFF. At the end of the programme the selector dial must be turned to position «O», to switch the machine off. 16 Select the delayed start by pressing the button 6 Press this button to select the required delay. The selected delay time value will appear on the display for few seconds, then the duration of the programme will appear again. You must select this option after you have set the programme and before you press the button 8. You can cancel the delay time at any moment, before you press button 8. If you have already pressed it, and you wish to cancel the delay time, proceed as follows: · set the washing machine to PAUSE by pressing button 8; · press the button 6 once. [. . . ] Directly into a drain pipe at a height of not less than 60 cm and not more than 90 cm. the inside diameter of the drain pipe must be larger than the outside diameter of the drain hose. For a correct functioning of the machine the drain hose must remain hooked on the proper support piece situated on the top part of the back side of the appliance. An additional drain hose and joining piece is available from your local Service Centre. [. . . ]