User manual ZANUSSI ZK19/7R3

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual ZANUSSI ZK19/7R3. We hope that this ZANUSSI ZK19/7R3 user guide will be useful to you.


ZANUSSI ZK19/7R3 : Download the complete user guide (401 Ko)

Manual abstract: user guide ZANUSSI ZK19/7R3

Detailed instructions for use are in the User's Guide.

[. . . ] Switching the dual--ring cooking zone off 87 87 87 Safety lock - barring the appliance or the cooking zones . . 91 91 91 91 92 The Timer Function as an Egg-Timer Setting the egg timer . . 94 94 94 70 Important Safety Information Read the operating instructions carefully before using the unit. Please pay particular attention to the safety information, which is designated with . [. . . ] The power level will be automatically switched off after a delay of 3 seconds. The desired dual--ring cooking zone (front--left or rear--right) must be activated. The control lamp (10) goes out, and the outer ring is switched off. 78 Safety lock - barring the appliance or the cooking zones Locking the appliance With the locking control (9), you can completely bar the use of the hob This function can be used as a child safety lock. If you do not switch off the Safety lock before switching off the hob, the Safety lock will still be active when you switch on the hob again. No other control can be operated until you switch off the Safety lock. 9 2 Locking (barring) the individual cooking zones If you are working with one or more cooking zones, you can lock each individual cooking zone. -By pressing the respective cooking zone control (2) again, the locking system is activated. If the cooking zone control (2) is pressed again, the dot appears, and the cooking zone can again be used. -- The locking system protects the following keys of the locked cooking zone from unintentional operation: Keys 4, 5, 6, 7. The timer key (7) can be operated, however, and can be set (see «The Timer Function as an Egg--timer» chapter), but has no influence on the barred cooking zone. 3 13 79 Boost facility This facility provides an initial heat boost to the cooking zone, before its resets to the lower power level selected. The length of the heat boost is dependent on the power level selected as shown in the table below. Selecting the boost facility 1. Using the increase control (5), select a power level between 1- You have 10 seconds in which -8. The cooking zone will now heat up at power level 9, and, after the defined time (see Table 1), will switch down to the selected power level. No decimal points (13) should be lit up in any of the power level indicators (3). Enter the desired time using the increase--decrease controls (4/5). 3 13 Switching the egg timer off If the time has already expired. . . «00» flashes for 10 seconds, an acoustic signal sounds for 2 minutes. -To switch off the acoustic signal before the 2 minutes has expired, press any key. . . . or if you want to switch the timer off early: 1. Using the decrease control (4), run the time down to «00». The timer function is now switched off. 7 To switch off quickly: -Simultaneously pressing the increase and decrease controls (5/4), the egg timer is switched off. 84 The right cooking utensils Energy consumption To save energy, you should . switch off the cooking zone a few minutes before the end of the cooking time, in order to make use of the residual heat. use the residual heat of the cooking zones for keeping food warm or for melting. Position pots and pans centrally on the cooking zones. --- Saucepans and frying pans Saucepans and frying pans should not be smaller than the cooking zone, and preferably not more than 10--15 mm larger than the diameter of the cooking zone. Check that the bottoms of utensils are smooth and undamaged; bottoms with burrs and sharp edges will scratch the ceramic glass surface. originating from the previous washing of vegetables), drawn over the cooking surface with the pan, or by burrs and the rims of pan bottoms. To avoid scratching or damaging the ceramic cooking surface, pots and pans should be moved on the plate by lifting them, and not by sliding. [. . . ] Model . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . You will find these details under «Technical data». Technical Data ZKT 662 HX ZKT 662 H ALU Hob dimensions length: depth: height: 572 mm 502 mm 48 mm Modell Prod. Nr. 941 591 740 ZKT 662 H alu Typ: 55GAD47AO 230 V AC 50 Hz Made in Germany Ser. Nr. : . 7, 0 kW Cut out dimensions length: depth: 560 mm 490 mm 230 V ~ 50 Hz 7. 0 kW Voltage Total power We reserve the right to make technical changes. 88 Unpacking and control Please examine the appliance for any damage sustained during transportation! [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE ZANUSSI ZK19/7R3




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual ZANUSSI ZK19/7R3 will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.