User manual ZANUSSI ZHP 631

[. . . ] Repairs carried out by unexperienced persons may cause injury or serious malfunctioning. Always insist on genuine spare parts. Child Safety This appliance has been designed to be operated by adults and children under supervision. Young children MUST NOT be allowed to tamper with the controls or play near or with the oven. Children should be KEPT AWAY until it has cooled. Environmental Information After installation, please dispose of the packaging with due regard to safety and the environment. [. . . ] After the setting is carried out, wait for 5 seconds: the "Cooking Duration" pilot lamp will come on and the display will revert to the time of day. When cooking time is over, the oven will be switched off automatically and an acoustic alarm will be heard, while the pilot lamp will start flashing. NOTE: when doing this operation, the oven will be operated again, therefore, remember to turn the oven function and the thermostat control knob to zero at the end of the cooking time. The relevant pilot lamp will flash and the display will show the remaining cooking time. After 5 seconds the pilot lamp will go out and the display will revert to the time of day. 6 Thanks to this function, you can set the oven to switch off automatically when a programmed end of cooking time is over. Place food in the oven, select a cooking function and adjust the cooking temperature. After the setting is carried out, wait for 5 seconds: the End of cooking pilot lamp will come on and the display will revert to the time of day. When cooking time is over, the oven will be switched off automatically and an acoustic alarm will be heard, while the pilot lamp will start flashing. NOTE: when doing this operation, the oven will be operated again, therefore, remember to turn the oven function and the thermostat control knob to zero when cooking is over. The relevant pilot lamp will flash and the display will show the programmed End of cooking time. The programmer will beep and the pilot lamp will go out. End of cooking function Cooking duration time combined and End of cooking The functions Cooking duration e End of cooking time can be used simultaneously to set the oven to switch on and off automatically at a later time. We reccomend a short oven pre-heating (about 10 minutes) before baking or cooking pizza. (*) If you need to cook more than one dish at the same time, we recommend you to place them on the levels quoted between brackets. Only experience will enable you to determine the correct setting to suit your personal requirements. 10 Cleaning and maintenance General Cleaning Before carrying out any cleaning or manteinance work, always disconnect the appliance from the electrical supply, and allow it to cool down. When using spray cleaning products, be careful not to spread them on the heating elements or on the thermostat sensor. Never use harsh abrasives, steel wool or cleaners with bleach, as they could damage the enamel and the oven door glass. The Oven Cavity The enamelled oven cavity is best cleaned whilst the oven is still warm. It is advisable to wipe the oven over with a soft cloth soaked in warm soapy water after each use. However, from time to time, it will be necessary to do a more complete cleaning, using a proper oven cleaner. In case of particularly tough stains, you can use stainless steel cleaning products or some warm vinegar. If cooking fruits, some over-heated natual acids can squeeze and settle on the oven enamel, causing stains quite difficult to remove. This could affect the enamel brightness, but it will have no consequence on the oven performances. To avoid these stains to be burnt out during the next cooking, carefully clean the oven cavity after all fruits cookings. The Oven Door and its gasket Before cleaning the oven door, we recommend you to remove it from the oven. [. . . ] The building-in and the electrical connection fo the appliance must be carried out by a qualified and authorized technician only. Building In It is important that the dimensions and materials of the surround or cabinet into which the oven will be built are correct and will withstand a temperature increase. A correct installation will have to ensure a proper protection against contact with electric parts or merely functionally isolated parts. All the units meant to ensure protection have to be fitted not to be taken away without using any tool. We recommed not to install the appliance near refrigerators or freezer, since the heat could affect the performance of these appliances. Fig. [. . . ]