User manual ZANUSSI ZDI122X

[. . . ] User manual Dishwasher ZDI 122 Thank you for selecting our appliance We wish you lots of enjoyment with your new appliance and we hope that you will consider our brand again when purchasing household appliances. Please read this user manual carefully and keep it throughout the product life cycle as a reference document. The user manual should be passed on to any future owner of the appliance. Contents Safety information _ _ _ _ _ _ _ _ _ _ _ _ _ 3 Control panel _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 4 Washing programmes _ _ _ _ _ _ _ _ _ _ _ 6 First use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 6 Set the water softener _ _ _ _ _ _ _ _ _ _ _ 7 Filling with dishwasher salt _ _ _ _ _ _ _ _ 9 Filling with rinse aid _ _ _ _ _ _ _ _ _ _ _ 10 Adjusting the dosage of rinse aid _ _ _ _ 11 Loading cutlery and dishes _ _ _ _ _ _ _ 11 Use of detergent _ _ _ _ _ _ _ _ _ _ _ _ _ 13 Unloading the dishwasher _ _ _ _ _ _ _ _ 14 Care and cleaning _ _ _ _ _ _ _ _ _ _ _ _ 15 Environmental concerns _ _ _ _ _ _ _ _ _ 16 Something not working _ _ _ _ _ _ _ _ _ 17 Technical data _ _ _ _ _ _ _ _ _ _ _ _ _ _ 19 Consumption values _ _ _ _ _ _ _ _ _ _ _ 20 Hints for test institutes _ _ _ _ _ _ _ _ _ _ 20 Installation _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 21 Subject to change without notice 2 Safety information In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the appliance are thoroughly familiar with its operation and safety features. [. . . ] The Clean up any rinse aid maximum level for filling is which overflows. Close the lid and press until it indicated by "max" locks. 10 CAUTION!This would damage the appliance. Top up the rinse aid indicator (B) becomes clear Adjusting the dosage of rinse aid Increase the dose if there are drops of water or lime spots on the dishes after washing. Reduce the dose if there are whitish streaks on the dishes or a bluish film on glassware or knife blades. Open the lid. Set the dosage level. (The Close the lid and press undose is factory set in po- til it locks. sition 4). Loading cutlery and dishes Sponges, household cloths and any object that can absorb water may not be washed in the dishwasher. · Before loading the dishes, you should: ­ Remove all left over food and debris. ­ Soften remnants of burnt food in pans · When loading the dishes and cutlery, please note: ­ Dishes and cutlery must not impede the rotation of the spray arms. When the basket is in the higher position you will not be able to use the cup racks. 31 cm 27 cm lower basket Move the front runner stops (A) of the upper basket outwards and slide the basket out. Refit the basket in the higher position and replace the stops (A) in their original position. 13 Use of detergent IMPORTANT!Observe the manufacturer's dosing and storage recommendations. Open the lid. Fill in the detergent in compartment A. Observe the dosing levels. For programmes with pre- When using detergent Close the lid. wash add an additional tablets: place detergent detergent dose in comtablets in compartment A. partmentB. Detergent tablets Detergent tablets from different manufacturers dissolve at different rates. For this reason, some detergent tablets do not attain their full cleaning power during short washing programmes. Therefore, please use long washing programmes when using detergent tablets, to ensure the complete removal of detergent residuals. Unloading the dishwasher · Hot dishes are sensitive to knocks. The dishes should therefore be allowed to cool down before removing from the appliance. 14 · Empty the lower basket first and then the upper one; this will avoid water dripping from the upper basket onto the dishes in the lower one. · Water may appear on the sides and the door of the dishwasher as the stainless steel will eventually become cooler than the dishes. CAUTION!When the washing programme has finished, it is recommended that the dishwasher is unplugged and the water tap turned off. Care and cleaning Cleaning the filters IMPORTANT!Incorrect repositioning and fitting of the filters will produce poor washing results. Clean filters A, B and C Turn the handle about 1/4 Remove filter A from the thoroughly under running turn anticlockwise and re- base of the washing comwater. partment. Put the flat filter A back in Replace the filters and the base of the washing lock by turning the handle compartment and ensure clockwise to the stop. that it fits perfectly under the two guidesD. 15 Cleaning the spray arms NEVER try to remove the spray arms. If residues of soil have clogged the holes in the spray arms, remove them with a cocktail stick. 1. [. . . ] Minimum - Maximum (MPa) place settings kg 0, 05 - 0, 8 12 38, 5 19 Noise level dB(A) 53 Consumption values The consumption values are intended as a guide and depends on the pressure and the temperature of the water and also by the variations of the power supply and the amount of dishes. Consumption values Programme Intensive 70° Normal 65° 65°A30' BIO 50° (Test programme for Test Institutes) Rinse and Hold Programme duration (in Energy consumption (in minutes) kWh) 85-95 105-115 30 140 1, 8-2, 0 1, 5-1, 7 0, 9 1, 05 Water (litres) 22-25 23-25 9 16 12 0, 1 5 Hints for test institutes Testing in accordance with EN 60704 must be carried out with appliance fully loaded and using the test programme (see "Consumption values"). Test in accordance with EN 50242 must be carried out when the salt container and rinse aid dispenser have been filled with salt and rinse aid respectively and using the test programme (see "Consumption values"). Full load: 12 standard place settings Amount of detergent required Rinse aid setting 5 g + 25 g (Type B) position 4 (Type III) 20 Upper basket Cutlery basket Lower basket cup racks: position A Installation WARNING!Any electrical and/or plumbing work required to install this appliance should be carried out by a qualified electrician and/or plumber or competent person. Only use, for connection to the water mains, new hose-set; old hose-set must not be reused. [. . . ]