User manual ZANUSSI ZDI100X

[. . . ] 156998720en. qxp 1/31/2007 4:22 PM Page 1 User manual Dishwasher ZDI 100 156998720en. qxp 1/31/2007 4:22 PM Page 2 Content Safety information - - - - - - - - - - - - - - - - - - -3 Control panel and functions - - - - - - - - - - - -4 Programme table - - - - - - - - - - - - - - - - - - -6 Before the first use - - - - - - - - - - - - - - - - - -7 Setting the water softener - - - - - - - - - - - - -8 Filling with dishwasher salt - - - - - - - - - - - -9 Filling with rinse aid - - - - - - - - - - - - - - - - -10 Adjusting the dosage of rinse aid - - - - - - -11 Loading cutlery and dishes - - - - - - - - - - - -11 Filling with detergent - - - - - - - - - - - - - - - -13 Unloading the dishwasher - - - - - - - - - - - -14 Cleaning and care- - - - - - - - - - - - - - - - - - 14 Environmental concerns - - - - - - - - - - - - - 15 Something not working - - - - - - - - - - - - - - 16 Technical data- - - - - - - - - - - - - - - - - - - - - 18 Consumption values - - - - - - - - - - - - - - - - 18 Hints for test institutes - - - - - - - - - - - - - - - 19 Installation - - - - - - - - - - - - - - - - - - - - - - - 19 European Guarantee - - - - - - - - - - - - - - - - 22 2 156998720en. qxp 1/31/2007 4:22 PM Page 3 Safety information In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. it is important to ensure that all people using the appliance are thoroughly familiar with its operation and safety features. Save these instructions and make sure that they remain with the appliance if it is moved or sold, so that everyone using it through its life will be properly informed on appliance use and safety. Correct use This dishwasher is only intended for washing household utensils suitable for machine washing. Knives and other items with sharp points must be loaded in the cutlery basket with their points down or placed in a horizontal position in the upper basket. [. . . ] If this is unavoidable, empty the machine, close the appliance door, disconnect the water inlet pipe and empty it. Moving the machine If you have to move the machine (moving house etc. . . . ): 1. Only transport the dishwasher in an upright position, otherwise salt water may run out. Prolonged periods of non-operation If you are not using the machine for any period of time you are advised to: 1. Leave the door ajar to prevent the formation of any unpleasant smells. Leave the inside of the machine clean. Environmental concerns Packaging material The packaging materials are environmentally friendly and can be recycled. Please dispose of the packaging materials in the appropriate container at the community waste disposal facilities. When a unit is no longer being used: - Pull the plug out of the socket. This prevents children from trapping themselves inside and endangering their lives. Old appliance The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product. 15 156998720en. qxp 1/31/2007 4:22 PM Page 16 Something not working IMPORTANT!Certain problems are due to the lack of simple maintenance or oversights, which can be solved with the help of the indications described in the chart, without calling out an engineer. Switch off the dishwasher, open the door and carry out the following suggested corrective actions. Fault code / malfunction The dishwasher does not fill with water. - continuous flashing of the start/cancel indicator light - 1 flash of the "end of programme" indicator light The dishwasher will not drain. - continuous flashing of the start/cancel indicator light - 2 flashes of the "end of programme" indicator light - continuous flashing of the start/cancel indicator light - 3 flashes of the "end of programme" indicator light The dishwasher door has not been properly closed. The water inlet hose has not been correctly laid or it is bent or squashed. The water drain hose has not been correctly laid or it is bent or squashed. Check the water drain hose connection. Close the water tap and contact your local Service Force Centre. Close the door Insert the mains plug The fuse has blown in the household Replace the fuse. If dishes are to be washed immediately, cancel the delay start. Once these checks have been carried out; close the door, switch on the dishwasher and press the start/cancel button. The programme will continue from the point at which it was interrupted. If the malfunction or fault code reappears contact the Service Force Centre. For other combinations of fault codes not described in the above chart, please contact your Service Force Centre. 16 156998720en. qxp 1/31/2007 4:22 PM Page 17 The wash results are not satisfactory The dishes are not clean The wrong washing programme has been selected. [. . . ] When the appliance is correctly levelled, the door will not catch on either side of the cabinet. If the door does not close correctly, loosen or tighten the adjustable feet until the machine is perfectly level. (See enclosed template). If necessary, have the domestic wiring system socket replaced. In case that the electrical cable has to be replaced, contact your local Service Force centre. [. . . ]