User manual ZANUSSI ZANS750

[. . . ] The items you place on the hob could easily catch fire when turning on the hob accidentally. Never leave the hob unattended when working with oil and fats because of the danger of fire. Sugar (solid or liquid) should never get onto the hot surface of the hob. They melt at high temperatures and can cause fissures and cracks when the hob cools down. [. . . ] Spills of sugar or melted plastic or aluminium material must be removed while the hob is still warm and before the remains have set. Use only pans with flat bases without rough edges to avoid remaining scratches. If any cracks appear on the hob surface, the hob has to be switched off immediately. Disconnect the appliance from the mains and inform the service department. A defective hob surface allows overboiling food to penetrate and the contact with live parts. ZANUSSI declines any liability should the appliance be used improperly and the safety measures not be observed. Keep these operating and assembly instructions! Unpacking and control Please examine the appliance for any damage sustained during transportation!If the appliance is damaged please immediately inform the forwarding company before the appliance is connected. The packing material should be disposed properly. Description of the appliance ZG 1102 / ZGW 1302 / ZGW 1302 X 1) Cooking zone 2) Cooking zone 3) Cooking zone 4) Cooking zone 180 mm 145 mm 180 mm 145 mm 1700 W 1200 W 1700 W 1200 W 2 3 1 4 Technical data Typ 011. 0 ZG 1102 Ser. No. 941 591 682 5. 8kW hob dimensions: length width height : 572 mm : 502 mm : 44 mm : 560 mm : 490 mm Instr. ZANUSSI cutout dimensions: length width voltage total power Typ 011. 0 Instr. ZANUSSI declines any liability should the appliance be used improperly and the safety measures not be observed. 15 Installation Cut out worktop to prescribed measurements of templates (saw exactly along the scribing). Using a standard or Phillips screwdriver, tighten the tension clamps evenly starting at the centre and moving diagonally until the built-in rim is tight on the worktop. Do not use an electric or pneumatic sdrewdriver without an adjustable safety clutch (pos. The installation of the control box or the oven will be carried out according to separate instructions. In order not to damage the appliance, the hob may only be connected to control boxes which are approved by the supplier of the ceramic hob. The distance between the underside of the hob and the furniture underneath must be at least 20 mm (see fig. 2). The electrical connection of the ceramic hob should only be carried out by a trained technician. The protection against accidental contact must be ensured by proper installation. Attention: If there are any repairs to be effected, the appliance must be non-tensioned (e. g. As soon as a crack is visible in the top, the appliance has to be disconnected from the mains. In terms of fire protection, the appliance conforms to type Y (IEC 335-2-6). [. . . ] As soon as a crack is visible in the top, the appliance has to be disconnected from the mains. In terms of fire protection, the appliance conforms to type Y (IEC 335-2-6). Only appliances of this type may be installed to cupboards or walls. cutout dimensions : 560 x 490 m m hob dimensions : 572 x 502 m m detail A Fig. 1 sealing glassceramic worktop bracket Fig. 2 20 16 321 321 321 321 321 321 321 321 321 321 321 321 321 321 321 What to do in case of a defect You are able to clear the following defects: When the cooking zone does not heat up after you switched it on?=> This is not a change in the material but burnt and not removed food remains. [. . . ]