User manual ZANUSSI TCE7224

[. . . ] Repairs carried out by inexperienced persons may cause injury or serious malfunctioning. Always insist on genuine spare parts. Child safety Use This appliance is designed for domestic use only. If the machine is used for any other purposes or is not used correctly, the manufacturer accepts no responsibility for any damage that might occur. Danger of explosion: Never tumble dry items that have been in contact with inflammable solvents (petrol, methylated spirits, dry cleaning fluid and the like). [. . . ] When operating the tumble dryer, the room temperature must not be lower than +5C and higher than +35C, as it may affect the performance of the appliance. 5 Stacking kit A special stacking kit is available through your dealer, to enable the mounting of the dryer on top of a front loading washing machine with cover's depth between 48 und 60 cm. Read carefully the instructions supplied with the kit before installing the dryer. P1148 Door reversal To make it easier to load or unload the laundry the door can be reversed. Please contact the nearest Service Centre. ENGLISH Use The control panel CONDENSER DRYER ELECTRONIC SENSOR TCE 7224 A 0 L B 60 90 30 A B C D E F G H J K L AUTOREVERSE E D C 1 1 Programme guide 2 3 45 67 8 6 Start button Press this button for about 2 seconds to start the dryer after having selected the programme. If the door of the appliance or the small door covering the condenser is opened while the programme is running, this button must be pressed again after closing the door in order to restart the programme from the point at which it was interrupted. This button must be depressed also after a power failure and after having re-inserted the water reservoir, if it has been emptied in the middle of a programme. In both cases light or (depending on the phase in progress) flashes to remind you that the start button needs to be pressed again. This will help you to select the correct programme for drying. 2 Mains-ON light Comes on when the appliance is switched on (ON/OFF button pressed down) and goes out when this button is released. 3 ON/OFF button This button is used to switch the dryer on. At the end of the programme, release this button by pressing it again to switch the dryer off. 4 Low temperature button Pressing this button allows drying to be performed at a lower temperature, for delicate items. If the button is not pressed, drying is performed at full power (2000 W). 7 Programme phase indicator lights These lights indicate the various phases of the programme as they are being performed. "Drying" light This light indicates that the appliance is in the drying phase. "Cooling" light 5 Buzzer OFF button A buzzer sounds by depressing the pushbuttons, during the anti-creasing phase, at the end of programme and when the water reservoir is full. Press this button when selecting the programme if you wish to switch the buzzer off during the anticreasing phase. At the end of drying, there is a 10 minute cooling phase to cool the laundry. to remove a persistent odour of moth-balls). Load It is often difficult to estimate the weight of items to be dried. We therefore recommend that you adopt the following guidelines: cotton, linen: drum full but not too tightly packed; synthetics: drum no more than half full; delicate fabrics: drum no more than one third full. 8 Operating sequence Before using your tumble dryer for the first time, we recommend to place a few damp cloths inside the appliance and dry for 30 minutes. There may be dust inside a brand new tumble dryer. Turn the programme selector dial to "0"; lights and go out. Release the ON/OFF button (the mains-ON light goes out) and immediately remove the laundry. After each use Drying 1. If the drying programme has to be stopped before it reaches the end, we recommend that you turn the programme selector dial to position (cooling) and wait until the end of this phase before removing the laundry. This will avoid a build-up of heat inside the appliance. To do this first turn the dial to "0" and then to and depress Start button . Modifying the programme To change a programme which is running, first cancel it by turning the programme selector dial to "0". Select the new programme and press the Start button . P1149 P1108 3. Please check the laundry does not get caught between the door and filter. If required, press the low temperature button and/or the buzzer OFF button . [. . . ] If this is not done a safety device trips: pilot light on the control panel comes on and the programme stops, leaving the laundry damp. Proceed as follows: When your laundry does not reach the desired degree of dryness, in other words, when it turns out either too dry or too damp, we advise you to clean the inside of the drum with a cloth soaked with vinegar. This will eliminate the slight patina that has formed in the drum (due to residues of detergent and softeners used in the washing, and to the lime contained in the water), which prevents the probes from detecting the correct degree of dryness. Pull out the reservoir Turn it upside down and let water flow down Re-fit the reservoir P1156 P1157 The reservoir must be re-inserted correctly. After inserting the reservoir the START-button has to be depressed again to allow the programme to continue. [. . . ]