User manual ZANUSSI IT5614

[. . . ] DISHWASHER IT 5614 152982 76/0 INSTRUCTION BOOKLET GB Contents For the user Important safety information Description of the appliance The control panel Before use Setting the water hardness Rinse aid Using your appliance Loading your appliance Adjusting the height of the upper basket Use of detergent Hints and tips Washing programmes Operating sequence Maintenance and cleaning Internal cleaning Cleaning the filters External cleaning Prolonged periods of non-operation Frost precautions Moving the machine Something not working Service and spare parts Protection against flooding Hints for test centres Technical specifications 3 4 4 5 5 7 8 8 9 10 11 12 13 14 14 14 15 15 15 15 16 17 17 18 18 For the installer Installation instructions Water supply connections Water outlet hose connection Electrical connection Building-in 19 19 20 20 21 Guide to use the instruction book The following symbols will be found in the text to guide you throughout the instructions: Safety instructions 1. Step by step Hints and tips Environmental information 2 Important safety information It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is left with the appliance in order that the new owner can get to know the functioning of the appliance and the relevant safety information. You MUST read it carefully before installing or using the appliance. Installation q q q Do not sit or stand on the open door. [. . . ] Crockery and cutlery On Off 65° 20 g 5g * BIO 50° with prewash ** Quick wash 55° Normal soil. Crockery and party crockery On Off BIO 50° 20 g 5g On Off 55° 25 g / * Testing programme for EN 50242 (see "Hints for Test Centres"). ** This is a special programme for quick washing a full load of lightly soiled dishes, glasses and crockery (except pots) so that you may re-use them promptly. 12 Operating sequence 1. Check the filters Ensure they are clean and properly positioned (see "Maintenance and cleaning"). 9. At the end of the washing programme At the end of the programme the dishwasher will stop automatically and an intermittent audible signal informs you that the programme has finished. The On/Off indicator light remains on until the "On/Off" push button is depressed. 2. Press the On/Off push button The On/Off indicator light comes on. 3. Pull the lower basket out and arrange the saucepans, plates and cutlery in it. Pull the upper basket out and arrange the plates, saucers, glasses and cups etc. Switch off the dishwasher Open the door and switch off the dishwasher by pressing the "On/Off" push button. Wait a few minutes before removing the dishes; in this way they will be cooler and the drying will be improved. Empty the lower basket first and then the upper one; this will avoid water dripping from the upper basket onto the dishes in the lower one. 5. Measure out detergent Add the required amount of detergent into the dispenser according to the dosage quantity given in the "Washing programmes" chart. Close the detergent dispenser lid. When the washing programme has finished, it is recommended that the dishwasher is unplugged and the water tap turned off. In general it is not advisable to open the door while the machine is working;if the door is opened however, a safety device ensures that the machine stops. 7. Set the programme The selection of the programme occurs with the door partially opened. Depress the programme button which corresponds to the washing programme you wish to select, the corresponding indicator light will flash. Important!Care must be taken if the door is opened during the hot phase or immediately after a programme has finished, as steam may escape. How to cancel a wash programme q If the door has not been closed and the wash programme has not started, to cancel the programme simply press the push button of a different wash programme. To change a wash programme in progress, open the door and press the push button corresponding to the programme under way for about 1 second, the relevant indicator light turns off. The dishwasher is now reset and you can select a new programme. q 8. The indicator light which corresponds to the programme under way is now permanently on. 13 Maintenance and cleaning Internal cleaning Ensure that the seals around the door, the detergent and rinse aid dispensers are cleaned regularly with a damp cloth. We recommend every 3 months to run a 65°C wash without dishes using detergent. Cleaning the central filters (After each wash) Inspect the central filters (B) and (C) and remove any scraps of food with a brush, under running water. Filters (B) and (C) are both removed by lifting up the outer one (B) (pulling the central funnel upwards); the smaller filter (C) can be removed by pressing the two tongues (D). [. . . ] The mains voltage corresponds to the voltage given in the "Technical specifications". The meter, fuses, mains power supply and wall socket can all take the maximum load required. Make sure that the socket and plug are compatible without having to use any type of adaptor. The manufacture accepts no liability for failure to observe the above safety precautions. This appliance complies with the following E. E. C. [. . . ]