User manual ZANUSSI CB 340 1C

[. . . ] ZANUSSI FRIDGE - FREEZER ZERB 8441 INSTRUCTION BOOK GB 200370292 A/ZE/14-1. (05. ) This instruction book contains safety precautions, information on use and helpful hints and tips. To ensure you use this appliance effectively and safely, please read this instruction book carefully before installing or using this appliance and retain for future reference. The symbols below help you to find things more easily: Safety precautions Warnings and Safety information Hints, useful information Environmental information The symbol on the product or on its packaging indicates that this product may not be treated as household waste. [. . . ] Never try to free an ice tray that is frozen to the freezer compartment by using pointed or sharp edged objects. 8 Hints and ideas In this chapter practical hints and ideas are given about how to use the appliance to reach maximum energy saving and there is environmental information about the appliance as well. How to save energy Avoid putting the appliance in a sunny place and near anything that gives off heat. Wrap products in tightly closing dishes or cling film to avoid building up unnecessary frost. Do not leave the door open longer than necessary and avoid unnecessary openings. Put warm foods into the appliance only when they are at room temperature. Important A temperature rise of the frozen food packs during defrosting may shorten their safe storage life. Never use sharp metal tools to scrape off frost from the evaporator as this could damage the appliance beyond repair. To Change the Light Bulb 1. Take the lamp cover off in the direction of the arrow and change the bulb. Spare bulbs are available from your local Service Force Centre. 10 If something does not work If the appliance is not working correctly, please carry out the following checks before contacting your local Service Force Centre. Symptom Possible cause It is too warm in the Thermostatic control can be set refrigerator. The melting water outlet flows not into the evaporative tray above the compressor. Check if the door closes well and the gasket remains clean and undamaded. Check if the door closes well and the gasket remains clean and undamaded. Place the products in a way so that cold air could circulate among them. Water flows at the back plate of the refrigerator. Replace the products so that they do not touch the back plate directly. Check if the doors close well and the gaskets remain clean and undamaded. Check if the doors close well and the gaskets remain clean and undamaded. There are too much frost and ice. The thermostatic control can be set wrongly. Neither cooling, nor lighting works. The appliance is noisy. Plug is not connected to the mains socket properly. instructions in chapter 'Putting it into There is no voltage in the mains socket. (Try to connect another appliance into it. ) The appliance is not supported properly. Check if the appliance stands stable (all the four feet should be on the floor). 11 If after the above checks your appliance still does not operate correctly, contact your local Service Force Centre. Please note that it will be necessary to provide proof of purchase for any in-guarantee service calls. In-guarantee customers should ensure that the above checks have been made, as the engineer will make a charge if the fault is. Ser vice and Spar e P ar ts In the event of your appliance requiring service, or if you wish to purchase spare parts, please contact your local Service Force Centre by telephoning:08705 929929 Your telephone call will be automatically routed to the Service Force Centre covering your post code area. For the address of your local Service Force Centre and further information about Service Force, please visit the website at www. serviceforce. co. uk Before calling out an engineer, please ensure you have read the details under the heading "Something Not Working. " When you contact the Service Force Centre you will need to give the following details: 1. [. . . ] Opening both doors fix the double door hinge onto the left side using the screws (2 pieces) (c). Be careful that the door edges are parallel with the edge of the top panel. Put over the handles (r) on the other side and put the plastic blanking pins (p) supplied in the plastic bag of this instruction book into the holes set free. (fig. 4) Put the appliance to its place, set it level, and apply to voltage it. [. . . ]