User manual X10 MS18A

[. . . ] Initializing Motion Detectors Remove the cover on the front of the Motion Detector and install 2 AA alkaline batteries in the compartment. Press and hold the TEST button on the back of the Motion Detector for 3-4 seconds and then release it. [. . . ] This clears the top line and shows * for each number entered. **** 12:00 am 5-6ft 30-40ft This takes you to the first level of the menu at step 1. INSTALL ZONE Now simply press the TEST button on the back of the Motion Detector (or turn the unit over so that it sees motion). The Console will acknowledge that it has been registered by displaying (for example) ZONE 3 SET. as you install more Motion Detectors. Testing the Motion Detector · Set the slide switch on the Motion Detector to position 1. Note: The Motion Detector will automatically return to normal operating mode after about 2 minutes. Battery Replacement If a zone has not reported in during the last four hours, the display will show PROBLEM. As long as the batteries have not completely failed they can be replaced with fresh batteries without the need to reinstall the Motion Detector. After removing the old batteries fresh batteries must be fitted within 30 seconds to ensure that the security code is retained. To test the Motion Detector: Once the batteries have been replaced, the Motion Detector should be tested as follows: · Make sure the system is NOT armed. The Console chimes to acknowledge and the zone # is displayed on the LCD. You will need to reinstall the Motion Detector following the directions in this instruction sheet. Motion Detector Model MS18A FCC Statement THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION. ANY CHANGES MADE TO THE UNITS WILL VOID THE USER'S AUTHORITY TO OPERATE THE EQUIPMENT. The X10 Supervised Security System includes a Security Console with an automatic dialer that calls friends or relatives in the event of a break in. [. . . ] There are also 2 hard wired inputs, which are zones 31 and 32. Please visit: http://www. x10. com/support for additional help and warranty conditions. Also see www. x10. com for more accessories that work with your Security System, including Lamp Modules and Wall Switch Modules to flash lights when the alarm trips, and remote controls that let you remotely control lights (and appliances) connected to X10 Modules. X10 Wireless Technology, Inc. [. . . ]