User manual X10 KR32A

[. . . ] Initializing Keyfob Remotes Press and hold the ARM button on the Keyfob remote for 3-4 seconds and then release it. This initializes the remote and picks a random code that is used when it is registered with the Console. [. . . ] This clears the top line and shows * for each number entered. **** 12:00 am This takes you to the first level of the menu at step 1. INSTALL ARMED HOME 12:00 am Entering the PIN clears the top line and shows * for each number entered. When you see INSTALL on the display. The Console acknowledges that it has been registered by beeping and displaying RMOT 1 SET. Press 2 to stay in the INSTALL menu. **** 12:00 am If the unit is armed it will disarm when the PIN is entered, and return to the time display, with DISARMED in the top line. DISARMED 12:00 am Then after a short delay the display reverts to HOME CONTROL mode. Panic Alarm: Pressing BOTH Panic buttons on the Keyfob remote at the same time trips the alarm, even if the system was not armed. Battery Replacement Providing the batteries have not already failed, they can be replaced with fresh batteries without the need to reinstall the remote. After removing the old batteries fresh batteries must be fitted within 30 seconds to ensure that the security code is retained. Gently pry the 2 halves of the Keyfob remotes case apart and install two CR2016 lithium batteries battery in the compartment (+ facing up). Once the batteries have been replaced, confirm that the remote is still registered in the Console by arming the system. If it does not arm, the code has been lost and you will need to proceed as described below. If the batteries have failed completely, the security code will have been lost. You will need to reinstall the Keyfob remote following the directions in this instruction sheet. Security Keyfob Remote Model KR32A FCC Statement THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION. ANY CHANGES MADE TO THE UNITS WILL VOID THE USER'S AUTHORITY TO OPERATE THE EQUIPMENT. The X10 Supervised Security System includes a Security Console with an automatic dialer that calls friends or relatives in the event of a break in. Accessories include battery powered Radio Frequency (RF) Door/Window Sensors, battery powered RF Motion Detectors, and RF Keyfob Remote Controls for arming and disarming the system. [. . . ] There are also 2 hard wired inputs, which are zones 31 and 32. Please visit: http://www. x10. com/support for additional help and warranty conditions. Also see www. x10. com for more accessories that work with your Security System, including Lamp Modules and Wall Switch Modules to flash lights when the alarm trips, and remote controls that let you remotely control lights (and appliances) connected to X10 Modules. X10 Wireless Technology, Inc. [. . . ]