User manual X10 IR7243W

[. . . ] The Infra-Red Mini-Controller lets you remotely control lights and appliances from the control of your armchair. Place it near your home entertainment system or by your bedside as you like. [. . . ] Note: For PRONTO remote control: If the IR7243 is set to house code P, then all commands coming from a Pronto remote control will be converted to powerline using the house code you set in the house code screen of a Pronto remote. When you press a front panel key of the IR7243, the housecode P will be transmitted. To control X10 device you need to enter the Home Automation code in your X-10 remote. To enter the code, please refer to the user guide of your remote control (same procedure as the setting of a VCR or SAT . Note that you need to dedicate one mode key of your remote control to this home automation code. Press the mode key dedicated to Home Automation on your remote control. Press the mode key dedicated to Home Automation on your remote control. Note: To control modules with unit codes higher than 9, on most X10 remote control, you can use the following keys : - "10", press the 0 key and then on (Chan+), off (Chan-), bright (Vol+) or dim (Vol-) - "11", press the A. B key and then on (Chan+), off (Chan-), bright (Vol+) or dim (Vol-) (or the record) key and then on (Chan+), off (Chan-), Bright - "12", press the (Vol+) or Dim (Vol-) - "13", press the key and then on (Chan+), off (Chan-), bright (Vol+) or dim (Vol-) - "14", press the key and then on (Chan+), off (Chan-), bright (Vol+) or dim (Vol-) - "15", press the key and then on (Chan+), off (Chan-), bright (Vol+) or dim (Vol-) - "16", press the --/- key and then on (Chan+), off (Chan-), bright (Vol+) or dim (Vol-) Press the mode key dedicated to Home Automation on your remote control. Press the mode key dedicated to Home Automation on your remote control. Press and release the on or off side of one of the four number keys corresponding to the Unit Code set on the Module(s) to be controlled. To change the light intensity : press on DIM/BRIGTH button (note : this feature works if your selected lamp is plugged into a "lamp" module) 3. to switch on all the lights : press "ALL LIGHTS ON" button 4. To switch off all the lights and appliances : press "ALL UNITS OFF" The Selector Switch determines which group of four Unit Codes will be affected (1-4 or 5-8). [. . . ] Om modules te bedienen met UnitCodes hoger dan 9, kunt u op de meeste afstandsbedieningen de volgende toetsen gebruiken: - "10", druk op de 0 toets gevolgd door on (Chan+), off (Chan-), bright (Vol+) of dim (Vol-) - "11", druk op de A. B toets gevolgd door on (Chan+), off (Chan-), bright (Vol+) of dim (Vol-) - "12", druk op de (of de record) toets gevolgd door on (Chan+), off (Chan-), bright (Vol+) of Dim (Vol-) - "15", druk op de key, gevolgd door on(Chan+), off (Chan-), bright (Vol+) of dim (Vol-) - "16", druk op de --/- toets, gevolgd door on (Chan+), off (Chan-), bright (Vol+) of dim (Vol-) [. . . ]