User manual X10 IN49A SETUP

[. . . ] SETUP INSTRUCTIONS Setting Up XRay Vision with Multiple Cameras Connect the Firecracker Computer Interface The Computer Interface (model CM17A) uses wireless signals to transmit X10 control commands from the computer to the transceiver module included in the kit. If there is already a device connected to this port, unplug it, connect the Computer Interface, and then plug the other device into the connector on the CM17A. [. . . ] Once again you need to download the software from: Set Up the Transceiver Module Make sure you have connected the Transceiver (model TM751) to a nearby power outlet. The outlet you use should not be too close to the back of your PC, as your PC may create some electrical noise that could reduce the range of the transceiver. Set the House Code (letter dial) on the Transceiver to the letter you will use for your cameras. Connect the Video Receiver to the Video Capture Adapter Plug the yellow video plug on the supplied cable into the Video Out jack on the VR30A. Connect the other end of the cable to the yellow Video In jack on the Video Capture Adapter. Make sure the Channel switch on the underside of the VR30A should be set to the same letter as that on the XCam2. Run the file Remote installation application and follow the installation instructions. You are now ready to connect to your XRay Vision server and download images. For more help, see: http://www. x10. com/support Your X10 multi-camera system allows you to control X10 XCam2TM cameras from your PC and view each camera from the XRay VisionTM software. Follow these instructions to set up the necessary hardware and software. [. . . ] Connecting the USB Video Capture Adapter When the installation program instructs you to, plug the Video to USB Converter connector into a USB port on your computer. The computer will recognize that new hardware has been installed and complete the installation. MODEL NUMBER: IN49A © Copyright 2000 X10 Wireless Technology, Inc. [. . . ]