User manual X10 IN46A SETUP

[. . . ] This kit gives you everything you need to view and control up to four cameras from your PC. Getting Started Before you begin the installation, you will need to select the locations and settings for the cameras. [. . . ] When the installation program instructs you to, plug the USB Video Adapter into a USB port on your computer. The computer will recognize that new hardware has been installed and complete the installation. Next, plug the Firecracker interface (model CM17A) into a serial port on your PC. Connect the PC Receiver (model MR26A) to the port on the Firecracker interface. Set the House Code on the wireless transceiver module (model TM751), plug it into an AC outlet and extend the antenna. Set the House Code on the ScanCam remote control (model CR12A) and insert 4 AAA batteries. If the cameras are going to be units other than 1-4, follow the instructions that came in the remote's box to change the scan controls. Adjust the antenna so that it it faces in the general direction of all the cameras -sometimes it may be best to point the antenna towards the ceiling. Set the House and Unit code on the addressable power supply (model XM10A) as you chose above (see Getting Started). The camera should come on and you should be able to get the picture on your PC. [. . . ] Follow the instructions in the box to set the House and Unit code to the same address as the camera in this location. Get more help at: http://www. x10. com/support GUIDE: IN46A Copywrite 2001 X10 Wireless Technology, Inc. [. . . ]