User manual X10 IN34A SETUP

[. . . ] PRO GUIDE 32-Piece ScanCam Kit Thank you for purchasing the X10 Pro 32 Piece ScanCam Kit! [. . . ] If the customer is already using X10 automation, choose a House Code that is not in use by any other modules or controllers. The cameras and their corresponding Eagle Eye motion sensors must be set to consecutive addressses within one of the following groups: 1-4, 5-8, 9-12 or 13-16. Set the House Code on the wireless transceiver module (model TM751), plug it into an AC outlet equidistant fromthe motion sensors and extend the antenna. Set the House Code on the ScanCam remote control (model CR12A) and insert 4 AAA batteries into it. If the cameras are going to be units other than 1-4 follow the instructions in that came with the remote control to change the scan controls. Connect the video receiver (model VR30A, found in the VK49A box) to the TV. Adjust the antenna so that it it faces in the general direction of all the cameras -- sometimes it may be best to point the antenna towards the ceiling. Set the House and Unit code on the addressable power supply (model XM10A) as you chose above (see Getting Started). [. . . ] Testing the System Once the installation is complete, you can check its operation by using the ScanRemote to switch from camera to camera while watching the picture on the TV. GUIDE: IN34A Copywrite 2000 X10 Wireless Technology, Inc. [. . . ]