User manual X10 IN28A SETUP

[. . . ] [. . . ] To get the most out of the Scan Controller kit and multiple ScanCams, you should set the addresses of the cameras within the following groups of four: 1-4, 5-8, 9-12 and 13-16. Installation Use a screwdriver to set the letter dial on the TM751 to the same letter (A-P) as the cameras you want to use the Scan Controller kit with. Plug In step 7, the section stating "Then, pressing either the blue UP or DOWN buttons scans forward or backward thru all 4 cameras. Each Camera turns on for a short period of time and then turns off before the next Camera turns on. " should read "Then, pressing either the blue UP or DOWN buttons will select the next or previous camera in the group after turning the current camera off. " Step 9 should say "To change the group of 4 codes for camera control from 1-4 to 5-8: press and hold the 5-ON button, then flip the 1-8/9-16 switch to the and then back to the left. " The instructions for 10 and 11 should be changed similarly. Transceiver Module the TM751 into an available 110V wall outlet. [. . . ] [. . . ]