User manual WHITES ELECTRONICS CM 300 S3

[. . . ] There are two ways to recover your computer: From Recovery Media From the recovery area Why do I have to create Recovery Media? Recovery Media are used to restore your computer back to its original factory condition. If Windows does not start and you have deleted the recovery area, you will need the Recovery Media to perform recovery. Create the Recovery Media immediately after the computer is ready for use. 1 2 Connect your computer to the Internet, download and install the latest updates using VAIO Update. [. . . ] If the User Account Control window appears, click Yes. To recover from the recovery area On models with the ASSIST button To recover from Recovery Media 1 If your computer is not equipped with a builtin optical disc drive, connect an external optical disc drive (not supplied) to the computer and to an AC power source. Insert Recovery Media into the optical disc drive while your computer is in Normal mode, turn off the computer, and then turn it on once again. If you are using the external optical disc drive, press the F11 key several times before the VAIO logo screen disappears. Press the or key to select Start VAIO Care Rescue and press the Enter key. To perform the custom recovery, select Tools and click Start advanced recovery wizard. When do I have to perform recovery? If your computer has been unstable If your computer has been infected with a 1 2 Press the ASSIST button while your computer is off to launch VAIO Care Rescue. To perform the custom recovery, select Tools and click Start advanced recovery wizard. 2 computer virus If your computer is experiencing problems which cannot be solved through troubleshooting If you have formatted the C: drive by mistake About backup What is a backup process? The backup process creates a backup copy of your data stored on the built-in storage device and saves it to another location. 3 3 3 1 Follow the on-screen instructions. Please create your Recovery Media immediately after setup. Which software should I use to maintain and recover my computer? Use the following software. VAIO Care Creating Recovery Media Checking your computer hardware VAIO Care Rescue Rescuing (backing up) your data Recovering your computer Erasing all the data on your built-in storage device See the help file included with VAIO Care and VAIO Care Rescue for more information. On models without the ASSIST button Why do I have to back up my data? Due to unexpected events or computer viruses, you might lose various data stored on your builtin storage device. If you are currently logged onto your computer as a standard user, you may be prompted to enter an administrator name and a password. Turn on your computer and press the F10 key several times before the VAIO logo screen disappears. Disconnect all connected USB devices (if any), and then restart your computer. Remove all extra memory modules you may have installed since purchase, and then restart your computer. If your computer is plugged into a power strip or an uninterruptible power supply (UPS), make sure the power strip or UPS is plugged into a power source and turned on. Reinstall the battery pack, plug the power cord or the AC adapter, and then turn on your computer. If you are using an external display, make sure it is plugged into a power source and turned on. The green power indicator light turns on but my screen remains blank Press the Alt+F4 keys several times to close the application window. Press the Ctrl+Alt+Delete keys and click the arrow next to the Shut down button and Restart. Press and hold the power button or slide and hold the power switch for more than four seconds to shut down your computer. Unplug the power cord or the AC adapter, and leave the computer for about five minutes. [. . . ] Then plug the power cord or the AC adapter, and turn on the computer again. Turning off your computer with the Ctrl+Alt+Delete keys, the power switch, or the power button may cause loss of unsaved data. A message appears notifying of either incompatibility or improper installation of the battery pack and my computer then enters Hibernate mode See the answers for "The charge indicator light is blinking fast and my computer does not start. " Windows does not accept my password and returns the message: Enter Onetime Password If you enter a wrong power-on password three times consecutively, the Enter Onetime Password message appears and Windows will not start. Press and hold the power button or slide and hold the power switch for more than four seconds to check that the power indicator light turns off. [. . . ]