User manual WHIRLPOOL WRX988SIBM

[. . . ] REFRIGERATOR USER INSTRUCTIONS THANK YOU for purchasing this high-quality product. If you should experience a problem not covered in TROUBLESHOOTING or PROBLEM SOLVER, please visit our website at www. You will need your model and serial number, located on the inside wall of the refrigerator compartment. 95 W10505281A REFRIGERATOR SAFETY Your safety and the safety of others are very important. [. . . ] EasySlide bin ■ Showroom Mode This mode is used only when the refrigerator is on display in a retail store. If you unintentionally turn on Showroom mode, the word “Showroom” will light up on the display. Exit Showroom mode by pressing and holding LIGHT and LOCK at the same time for 3 seconds. Refrigerator Features Temperature Controlled Exterior Drawer IMPORTANT: This control sets the temperature for this drawer only. Use the full-width drawer to store large party platters or deli trays, or use a drawer organizer to store smaller items such as yogurt, juice boxes and lunch meat for easy access. Temperatures have been preset for the storage of: Cold Drinks, Meats/Cheeses, Assorted Items and Fruits/Vegetables. Grasp the front of the bin with both hands, and lift up on the front to remove. Align the center rib and tabs on the EasySlide bin with the ribs and slots in the cabinet. Grasp the handle at the bottom of the drawer and slide the drawer straight out to the stop. Replace the drawer by placing it on the bottom drawer guide and pushing it past the drawer stop into position. Holding the glass insert firmly with one hand, press up in center of glass insert until it rises above the plastic frame. Fit back of cover frame into supports on side walls of the refrigerator and lower the front of the cover frame into place. Slide rear of glass insert into cover frame and lower front into place. 18 Water and Ice Dispensers IMPORTANT: ■ Allow 3 hours for the refrigerator to cool down and chill water. The dispensing system will not operate when either the refrigerator door or freezer drawer is open. Press and hold the OPTIONS and LOCK buttons at the same time for 3 seconds. The words “Back” and “1 Cup” will appear on the display screen. Also, the Calibrate Measured Fill icon will illuminate and remain lit while the Measured Fill feature is being calibrated. – Flush the Water System Air in the water dispensing system can cause the water dispenser to drip. After connecting the refrigerator to a water source or replacing the water filter, flush the water system. Flushing the water dispensing system forces air from the water line and filter and prepares the water filter for use. NOTE: As air is cleared from the system, water may spurt out of the dispenser. [. . . ] Service calls to repair or replace appliance light bulbs, air filters or water filters. Damage resulting from accident, alteration, misuse, abuse, fire, flood, acts of God, improper installation, installation not in accordance with electrical or plumbing codes, or use of products not approved by Whirlpool. Cosmetic damage, including scratches, dents, chips or other damage to the finish of your major appliance, unless such damage results from defects in materials or workmanship and is reported to Whirlpool within 30 days from the date of purchase. Any food or medicine loss due to refrigerator or freezer product failures. [. . . ]