User manual WHIRLPOOL WRT111SFAW INSTALLATION GUIDE

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual WHIRLPOOL WRT111SFAW. We hope that this WHIRLPOOL WRT111SFAW user guide will be useful to you.


WHIRLPOOL WRT111SFAW INSTALLATION GUIDE: Download the complete user guide (610 Ko)

You may also download the following manuals related to this product:

   WHIRLPOOL WRT111SFAW ENERGY GUIDE (284 ko)
   WHIRLPOOL WRT111SFAW DIMENSION GUIDE (86 ko)
   WHIRLPOOL WRT111SFAW USE & CARE GUIDE (1360 ko)
   WHIRLPOOL WRT111SFAW WARRANTY INFORMATION (90 ko)

Manual abstract: user guide WHIRLPOOL WRT111SFAWINSTALLATION GUIDE

Detailed instructions for use are in the User's Guide.

[. . . ] Complete and mail the Product Registration Card or register online at www. U-LineService. com. Once your unit is installed, keep the Use and Care Guide and this Installation Guide in a safe place for future reference. Black units have drawers with top handles designed for the installation of full overlay drawer panels. When full overlay panels will not be used, replacement handles MUST be installed (part number 2607001). [. . . ] Overlay panel will not sit flush to drawer if mounting hardware is not counter bored. Tape Back of Wood Panel Drawer Panel IMPORTANT The thickness of the wood overlay panel must be 3/4". The door panel must not weigh more than 20 lbs. Drawer Panel Installation Removing Existing Drawer Fronts 1. Start in the middle and pull outward, moving toward the edge (see Figure 7). If either drawer is not aligned, carefully follow instructions to remove that drawer, make the necessary adjustment and re-install the drawer. Figure 11 IMPORTANT Drawer panel and overlay panel must be aligned properly or the drawer will not operate correctly. Install the assembled panel by sliding the original door panel back into the drawer front. Replace the handle assembly and secure with the two screws removed in Step 2 under Removing Existing Drawer Fronts. Starting at the corners and working toward the center, push the drawer gasket back into place. Go on to 5 Adjust Drawers. 06/2006 9 www. U-LineService. com CO2175DWR -- Ice Maker/Refrigerator Adjusting Drawer Alignment WARNING SHOCK HAZARD -- The unit must be unplugged from the wall outlet during drawer removal, adjustment and re-installation. Minor Adjustment: Note: The mounting holes on the slide are slightly larger than the screws' diameter. Push the slide backward. Push Slide Backward Loosen Mounting Screws Drawer Removal 1. Figure 15 Severe Adjustment: Note: The slides have extra mounting holes that may be used. Remove the slide's mounting screws. Mark and Drill New Mounting Holes CAUTION Use care when handling the drawer. Plug in the drawer's connection wiring (top drawer only). Front View of Unit Top View of Unit Figure 20 See Figure 20. The drawer will need a Top-to-Bottom Adjustment if, when viewed from the front, the drawer is not level horizontally. This is caused by one of the slides being mounted higher than the other slide on the unit's liner. 4. Go on to 6 Prepare Plumbing. 06/2006 11 www. U-LineService. com CO2175DWR -- Ice Maker/Refrigerator 6 Prepare Plumbing Plumbing installation must observe all state and local codes. All water connections MUST BE made by a licensed/ qualified plumbing contractor. Failure to follow recommendations and instructions may result in damage and/or harm. 2. Slide the compression fitting and ferrule over the 1/4-inch Outside Diameter water supply line. Using two wrenches, tighten the compression fitting on the supply line (see Figure 24). Carefully bend the water supply line into position and connect the line to the solenoid valve (see Figure 25). Avoid kinking the water supply line. WARNING To prevent accidental electrocution, make certain that the floor surfaces surrounding the unit are dry whenever power is removed from, or applied to, the unit. Water Supply Connection When connecting the water supply, follow these guidelines: · Review the local plumbing codes before you install the unit. · Install a shut-off valve in the 1/4 inch Outside Diameter water supply line. [. . . ] · Make sure the mounting screws attaching the unit to the counter, cabinet or wall are deep enough into the mounting surface to support the weight of the drawers and the items that will be inside the drawers. · Never use the drawers as steps or as a shelf to support more than the drawers' content. After leveling, the unit must be secured to a counter, a cabinet or a wall to prevent tipping. Open the upper drawer to expose the six screws (A) installed at the top two corners (three at each corner). [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE WHIRLPOOL WRT111SFAW




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual WHIRLPOOL WRT111SFAW will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.