User manual WHIRLPOOL WRB329DMBM DIMENSION GUIDE

[. . . ] We have provided many important safety messages in this manual and on your appliance. This symbol alerts you to potential hazards that can kill or hurt you and others. All safety messages will follow the safety alert symbol and either the word “DANGER” or “WARNING. € These words mean: DANGER WARNING You can be killed or seriously injured if you don't immediately follow instructions. [. . . ] NOTE: While dispensing water and for 3 seconds after dispensing has stopped, the digital display will show how much water has been dispensed. To dispense water, press a sturdy glass against the water dispenser pad OR place the glass below the water dispenser and press the MEASURED FILL button. NOTE: While dispensing water, the digital display will count down how much water remains to be dispensed, according to the volume you selected. The flow of water will automatically stop once the desired volume has been dispensed. To stop dispensing before the selected volume has been dispensed, remove the glass from the dispenser pad OR press the MEASURED FILL button a second time. NOTE: If you stop dispensing before the desired volume has been dispensed, the digital display will continue to show how much water remains to be dispensed. To select a new volume or start dispensing the same volume again, you must first finish dispensing the selected volume, or turn off the Measured Fill feature (either by waiting 1 minute so it will automatically turn off or by pressing ICE TYPE to manually turn it off) and then turn it back on. To Dispense Water (Measured Fill): Measured Fill allows you to dispense a specified amount of water with the touch of a few buttons. IMPORTANT: Low water pressure may affect the accuracy of this feature. 7 The Ice Dispenser Ice dispenses from the ice maker storage bin in the freezer when the dispenser pad is pressed. Before dispensing ice, select which type of ice you prefer by pressing the ICE TYPE button. The switch is located on the freezer door, on the left side of the wall that surrounds the ice storage bin. ON DIM PADS 8 ■ ■ To turn on the ice maker, slide the control to the ON (left) position. To manually turn off the ice maker, slide the control to the OFF (right) position. Style 2 Turning the Ice Maker On/Off: ■ ■ NOTE: The ice maker has an automatic shutoff to keep the storage bin from overfilling during normal operation. The ice maker sensors will automatically stop ice production, but the control will remain in the ON (left) position. To manually turn off the ice maker, lift the wire shutoff arm to the OFF (arm up) position and listen for the click. Use both hands to hold the base of the storage bin, then lift it up and out. NOTE: The ice maker has an automatic shutoff to keep the storage bin from overfilling during normal operation. As ice is made, the ice cubes will fill the ice storage bin, and the ice cubes will raise the wire shutoff arm to the OFF (arm up) position. Release lever NOTE: It is not necessary to turn the ice maker control to the OFF (right) position when removing the storage bin. The sensor cover (“flipper door”), located on the right wall of the freezer door, stops the ice maker from producing ice if the door is open or the storage bin is removed. [. . . ] see “Water and Ice Dispensers” or “Water Dispenser. While testing was performed under standard laboratory conditions, actual performance may vary. Based on the use of Cryptosporidium parvum oocysts Fibers greater than 10 um in length ® NSF is a registered trademark of NSF International. €† † 14 WHIRLPOOL CORPORATION MAJOR APPLIANCE WARRANTY LIMITED WARRANTY For one year from the date of purchase, when this major appliance is operated and maintained according to instructions attached to or furnished with the product, Whirlpool Corporation or Whirlpool Canada LP (hereafter “Whirlpool”) will pay for Factory Specified Parts and repair labor to correct defects in materials or workmanship that existed when this major appliance was purchased. [. . . ]