User manual WHIRLPOOL WOD93EC7AS INSTALLATION GUIDE

[. . . ] ■ Tools needed ■ ■ ■ ■ ■ ■ Phillips screwdriver Measuring tape Hand or electric drill (for wall cabinet installations) 1" (2. 5 cm) drill bit (for wall cabinet installations) Level Flat-blade screwdriver ■ Recessed installation area must provide complete enclosure around the recessed portion of the oven. 6 cm) maximum below the support surface when the oven is installed in a wall cabinet. 5 cm) minimum diameter hole should have been drilled in the right rear or left rear corner of the support surface to pass the appliance cable through to the junction box. [. . . ] Locate the oven door latches in both corners of the oven door, and rotate the latches forward to the unlocked position. WARNING Excessive Weight Hazard Use two or more people to move and install oven. To avoid floor damage, set the oven onto cardboard prior to installation. Remove the hardware package from inside the bag containing literature. If installing a single oven below a cooktop, remove the adhesive backing from the foam strip and press it to the back of the control panel. NOTE: When the cooktop is installed in the cabinet, the top edge of the foam strip should be approximately ³⁄₈" (10 mm) from the top edge of the control panel. Grasp the edges of the oven door with both hands and close the oven door until it will no longer close. 6 Positioning Oven Feet for Multiple Cabinet Cutout Heights Single Ovens The positioning of the oven feet allow a single oven to be installed in a cutout height between 26¹⁵⁄₁₆" (68. Refer to the following instructions to position the feet for the size of your cabinet cutout. Remove the foot from the right front spacer by removing the #8-18 x ³⁄₈" screw. In the same manner, remove the feet on the right rear, left front, and left rear of the oven. Using 2 or more people, place the oven on its back on a covered surface. Using 2 or more people, place the oven on its back on a covered surface. Remove the foot from the right front spacer by removing the #8-18 x ³⁄₈" screw. Double Ovens The positioning of the oven feet allow a double oven to be installed in a cutout height between 48⁷ Refer to the following instructions to position the feet for the size of your cabinet cutout. Rotate the foot 90° so the short side of the foot is positioned toward the top of the oven. Reinstall the foot to the spacer using the #8-18 x ³⁄₈" screw previously removed. In the same manner, remove, rotate and reinstall the feet on the right rear, left front, and left rear of the oven. Using 2 or more people, place the oven on its back on a covered surface. Install a foot on the left rear spacer using a #8-18 x ³⁄₈" screw. NOTE: Position the foot so the long side of the foot is facing toward the top of the oven. Using 2 or more people, place the oven on its back on a covered surface. [. . . ] The display panel will light briefly, and “PF” should appear in the display. If the display panel does not light, reference the “Assistance or Service” section of the Use and Care Guide or contact the dealer from whom you purchased your oven. Using one #8-18 x ³⁄₈" screw (E) on each side of the vent tab (B), fasten the vent securely to the oven. If there is an extra part, go back through the steps to see which step was skipped. [. . . ]