User manual WHIRLPOOL UXW7230BSS

[. . . ] 2 CM) WALL-MOUNT CANOPY RANGE HOOD Installation Instructions and Use & Care Guide For questions about features, operation/performance parts, accessories or service, call: 1-800-253-1301 In Canada, for assistance, installation and service, call: 1-800-807-6777 or visit our website at. 30 2 RANGE HOOD SAFETY Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. This symbol alerts you to potential hazards that can kill or hurt you and others. [. . . ] follow the electrical connector manufacturer's recommended procedure. Aluminum/copper connection must conform with local codes and industry accepted wiring practices. 2 cm) round vent Calculating Vent System Length To calculate the length of the system you need, add the equivalent feet (meters) for each vent piece used in the system. 8 m) ■ Wire sizes and connections must conform with the rating of the appliance as specified on the model/serial rating plate. The model/serial plate is located behind the filter on the rear wall of the range hood. Wire sizes must conform to the requirements of the National Electrical Code, ANSI/NFPA 70 (latest edition), or CSA Standards C22. 6 m) The following example falls within the maximum recommended vent length of 35 ft (10. 9 m) 7 INSTALLATION INSTRUCTIONS Prepare Location ■ It is recommended that the vent system be installed before hood is installed. Before making cutouts, make sure there is proper clearance within the ceiling or wall for exhaust vent. Check your ceiling height and the hood height maximum before you select your hood. Mark centers of the fastener locations through the template to the wall. If there is no wood to screw into, additional wall framing supports may be required. 8 mm) pilot holes at all locations where screws are being installed into wood. 4 mm) gap between the wall and the back of the screw head to slide range hood into place. WARNING Excessive Weight Hazard Use two or more people to move and install range hood. Vent Cover Support Bracket Installation Installations using telescoping upper and lower vent cover assembly 1. Determine and mark the centerline on the wall where the canopy hood will be installed. Tape template in place, aligning the template centerline and bottom of template with hood bottom line and with the centerline marked on the wall. Determine and make all necessary cuts in the wall for the vent system. NOTE: To get the most efficient use from your new range hood, read the “Range Hood Use” section. Connect green (or bare) ground wire from home power supply to the 2 yellow-green ground wires (D) in terminal box using UL listed wire connectors. 10 RANGE HOOD USE The range hood is designed to remove smoke, cooking vapors and odors from the cooktop area. [. . . ] This limited warranty is valid only in the United States or Canada and applies only when the major appliance is used in the country in which it was purchased. Outside the 50 United States and Canada, this limited warranty does not apply. Proof of original purchase date is required to obtain service under this limited warranty. iTEMS EXCLUDED FROM WARRANTY This limited warranty does not cover: 1. [. . . ]