User manual WHIRLPOOL LPA58EG/WH PROGRAM CHART

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual WHIRLPOOL LPA58EG/WH. We hope that this WHIRLPOOL LPA58EG/WH user guide will be useful to you.


WHIRLPOOL LPA58EG/WH PROGRAM CHART: Download the complete user guide (1544 Ko)

You may also download the following manuals related to this product:

   WHIRLPOOL LPA58EG/WH SCHEDA PRODOTTO (57 ko)
   WHIRLPOOL LPA58EG/WH SCHEDA PROGRAMMI (1548 ko)
   WHIRLPOOL LPA58EG/WH PRODUCT FICHE (52 ko)

Manual abstract: user guide WHIRLPOOL LPA58EG/WHPROGRAM CHART

Detailed instructions for use are in the User's Guide.

[. . . ] Quick reference guide Chart BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ THIS QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING ANY BUTTON EXCEPT CANCEL/OFF BUTTON. FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES AUTOMATICALLY AFTER 30 SECONDS IF NO CYCLE HAS STARTED. (see at right for options description) Options and display description SALT INDICATOR When lit (at the end of the cycle), the salt reservoir needs to be refilled. RINSE AID INDICATOR When lit (at the end of the cycle), the rinse aid dispenser needs to be refilled. PROGRAM SELECTION BUTTON Push “Programs” button (repeatedly) until the indicator of the required program lights up (see “Table of programs” below). START/RESUME BUTTON Push this button to start the selected program: the indicator lights up and goes off at the end of the program. [. . . ] if you want to insert an item): To Cancel the program on running: To change the program in progress: - Open the door with caution (the program pauses) and insert the item/s, (beware of HOT steam!). - Close the door and press the START button again to restart the cycle (the program resumes the cycle from where it was interrupted). - Press the CANCEL/Off button. - (Water drains for up to 1 minute then the appliance switches off). - Press the CANCEL/Off button to cancel the program on running. - Press any button except CANCEL/Off button to switch on the appliance. Everything OK. . . 8 9 After the program is completed appliance turns into Standby mode automatically. Unload the appliance starting from the lower rack in order to avoid any residual drips of water falling onto crockery below. Maintenance and care Maintenance and care Screw on microfilter NOTE MARK!Insert Filters Check and clean if necessary Rectifying minor faults yourself. . . 10 Insert and screw on upper and lower arms tightly. Clean spray nozzles under running water (use toothpicks if necessary). . . Spray arms Remove blockages/ deposits. GB -5- What to do if. . . If a fault occurs, before contacting the After-sales Service, make the following checks to try and remedy the problem. Most faults can be remedied by taking the following courses of action, quickly restoring normal appliance operation. - Check whether the “Delayed start” option (if available) has been selected. If it has, the appliance will only start once the set time has elapsed. Loading of the dishwasher using lower and upper rack - If you select the “Half load/Multizone” option (if available), remember to load only the upper rack or only at the same time with “Half load/Multizone” option. the lower rack to increase washing power and thus obtain optimum wash results. - In the event of frequent use of the Eco 50°C program (if available), from time to time select the Intensive Frequent use of Eco 50°C. - The spray arms must not be clogged, the filters must not be dirty and must be fitted correctly (see page 5, Clogged spray arms, dirty filters or not fitted correctly. - The spray arms must be able to turn freely and must not be impeded by crockery or cutlery. GB -6- What to do if. . . Crockery and cutlery. . . . . . salt indicator lit . . . have deposits: regeneration salt residue . . . are not dry Possible causes. . . - Set “Tablet” option; if this option is not available, it is normal for the salt indicator to light up. - In areas with very hard water, more regeneration salt needs to be added (see page 2, “How to set water hardness”). - Synthetic materials do not dry well; if wet at end of cycle, wipe dry. Clean dishes left in dishwasher for a long time after end - In this situation, the presence of drops of water on dishes and on the sides of the dishwasher is normal. - Increase the dosage of rinse aid (see page 3, “Adding rinse aid”). - The Rapid program 40°C / 45°C is intended for quickly washing lightly soiled dishes. [. . . ] Safety warnings - The appliance is not intended for use by children or physically or mentally impaired persons, unless adequately supervised by a responsible adult capable of guaranteeing safe use of the appliance. - Do not store flammable materials in close proximity to the dishwasher. - The open dishwasher door can only support the weight of the loaded rack when pulled out. knives), must be placed in the cutlery basket with the sharp end facing downwards. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE WHIRLPOOL LPA58EG/WH




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual WHIRLPOOL LPA58EG/WH will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.