User manual WHIRLPOOL AWOD4927

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual WHIRLPOOL AWOD4927. We hope that this WHIRLPOOL AWOD4927 user guide will be useful to you.


WHIRLPOOL AWOD4927 : Download the complete user guide (924 Ko)

You may also download the following manuals related to this product:

   WHIRLPOOL AWOD4927 (872 ko)
   WHIRLPOOL AWOD4927 (872 ko)

Manual abstract: user guide WHIRLPOOL AWOD4927

Detailed instructions for use are in the User's Guide.

[. . . ] INTENDED USE This washing machine is exclusively destined to treat machine washable laundry in quantities which are usual for private households. • Observe the instructions given in these Instructions for Use and the Programme Chart when using the washing machine. • Keep these Instructions for Use and the Programme Chart; if you pass on the washing machine to another person, also give him/her Instructions for Use and Programme Chart. SAFETY AND GENERAL RECOMMENDATIONS 1. Safety instructions • The washing machine is appropriate for indoor use only. [. . . ] They may harm the plastic surfaces or other parts. Cleaning the detergent dispenser 1. Press with your finger on the small depression over the “PUSH” marking (picture “A”) to release the drawer and pull it out completely. Remove the siphon from the softener chamber by pulling it upwards (picture “B”). Refit the siphon in the softener chamber by pushing it down until it stops; then push the dispenser drawer back into the dispenser compartment. A B Water inlet hose(s) (picture C, D or E - depending on model) Check regularly for brittleness and cracks. In case of a damage, replace it by a new hose of the same type, available through our After-Sales Service or your specialist dealer. If the inlet hose of your washing machine corresponds with the model on picture “D”, periodically check the safety valve inspection window: if it is red, the hose’s waterstop function was triggered, and the hose must be exchanged by a new one from our After-Sales Service or your specialist dealer. This model may have a release lever which must be pressed down while unscrewing the hose. If your supply hose has a transparent hose coating (picture “E”), periodically check the colour; if it intensifies locally, the hose may have a leak and should be replaced. Contact our After-Sales Service team or specialist dealer to obtain a replacement hose. C Release lever Cleaning the mesh filter in the water inlet hose(s) D 1. Clean the internal mesh filter and screw the water inlet hose back onto the tap. Pull off the mesh filter from the washing machine connection with universal pliers and clean it. Turn on the tap and ensure that the connections are completely water-tight. Safety valve inspection window E GB 8 TROUBLESHOOTING GUIDE Your washing machine is equipped with various automatic safety functions. These enable faults to be detected in good time and the safety system can react appropriately. These faults are frequently so minor that they can be removed within a few minutes. Problem Appliance does not start, no indicators are on Appliance does not start although “Start(Pause)” has been pressed Causes - Solutions - Tips • Plug is not properly inserted in socket. • Socket or fuse does not function correctly (use a table lamp or similar appliance to test it). • The “Child lock/Lock buttons” feature has been activated (if available on your model). To unlock the buttons, push the two buttons marked with the key symbol simultaneously and hold them at least for 3 seconds. The key symbol on the display disappears and the programme can be started. For draining the water without spinning, select “Drain” programme (if available) or press the “Reset/Drain” button for at least 3 seconds. • Programme has been changed - reselect desired programme and press “Start/Pause”. • Programme has been interrupted and eventually door has been opened - close door and restart programme by pressing “Start(Pause)”. • The appliance’s safety system has been activated (see “Failure indicators” in your programme chart). [. . . ] Push the plastic caps delivered with your washing machine on the holes to close them (pict. ADJUSTMENT OF THE FEET The appliance must be installed on a solid and level floor surface (if necessary use a spirit level). If the appliance is to be installed on a wooden or floating floor, distribute the weight by placing it on a sheet of plywood measuring at least 60 x 60 cm and thickness of at least 3 cm which is secured to the floor. If the floor is uneven, adjust the 4 levelling feet as required; do not insert pieces of wood etc. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE WHIRLPOOL AWOD4927




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual WHIRLPOOL AWOD4927 will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.