User manual WHIRLPOOL AWO 3561 PROGRAM CHART

[. . . ] When the combination of programme, additional options and temperature is not possible, the indication lights switch off automatically. Unsuitable combinations of options are deselected automatically. Special options Start Delay Départ retardé Easy Ironing Antifroissage Prewash Prelavage Intensive Rinse Rinçage plus Rinse Hold ACP Spin Speed Reduction Essorage Variable Max Spin Speed rpm D FG HI J K Detergents and additives Programme Care Labels Max Load Type of wash/Notes Kg Softener Main Wash Prewash Cotton Coton Normally to heavily soiled bed linen, table linen and underwear, towels, shirts etc. For temperature selection, please respect the manufacturer's recommendation on the care label. With heavily soiled laundry the additional “Prewash” option can be selected as well. [. . . ] START DELAY The “Start Delay” allows to run the machine at the consumer’s convenience, for example at night when electricity is cheaper. • Press the “Start Delay” button to select the delay time by 1 to 23 hours; • Press the “Start/Pause” button. The indication next to the “Start Delay” button lights up and goes off when the programme starts. • The time delay indication disappears when the programme starts and it is replaced by the remaining time. • The number of hours preselected can later be reduced pressing again the “Start Delay” button. To cancel the “Start Delay” . . before you press the “Start/Pause” button: • Turn the programme selector to the “Off/0” position. • Reselect the desired programme and options and press “Start/Pause” button to start the programme. . . after having pressed the “Start/Pause” button: • Press the “Reset” button for at least 3 seconds the start delay time disappears from the remaining time display, then • either start the chosen programme by pressing the “Start/Pause” button twice • or turn the programme selector knob to the “Off/0” position and choose another programme. PROGRAMME START Open the tap and press the “Start/Pause” button. The indication next to the “Start/Pause” button lights up. After starting the programme, the sequence indication runs from left to right through Wash, Rinse, Spin. When the sequence of the programme is finished the corresponding indication goes out. RED INDICATIONS “Water Tap Closed” The appliance has no or insufficient water supply. Open the water tap; if the indication still lights up, refer to the “Troubleshooting Guide” in the Instructions for Use. Check whether the drain hose is kinked or the filter must be cleaned; in the latter case refer to the Instructions for Use (“Removing the Filter”). “Door Locked” As long as a washing programme is running, the lamp lights up to show that the door cannot be opened. PROGRAMME END • The remaining time is on “0:00” and all the lights of the programme sequence indication are off. Select the new programme (with temperature), any options and another spin speed if you want. The new programme continues at the same position where the previous programme was interrupted. CANCEL (RESET) A RUNNING PROGRAMME BEFORE THE END The “Reset” button cancels a programme before the end. Any existing water is drained out before the door can be opened. Prewash cycle might increase programme duration. [. . . ] • This option is particularly suitable for areas with very soft water, washing baby linen and helps people with allergies. “Rinse Hold” button • The laundry remains in the last rinse water without progressing to the final spin cycle to avoid creasing and prevent colours from changing. • This option is particularly recommended for the programme “Synthetic”, “Daily” and “Delicates”. • This function is particularly useful if you want to postpone spinning to a later time, or if you want to drain only. [. . . ]