User manual WHIRLPOOL AKR 961 IX INSTRUCTION FOR USE

[. . . ] Packaging The packaging material is entirely recyclable, and marked with the recycling symbol . Keep the packaging materials (plastic bags, polystyrene parts, etc. ) out of reach of children, as they are potentially dangerous. Disposal must be carried out in accordance with local environmental regulations for waste disposal. [. . . ]  Close the steam deflector (where fitted). CARE AND MAINTENANCE Always disconnect the hood by switching off the electrical power supply before cleaning or carrying out maintenance. Grease filter The sponge grease filter should be washed in hot soapy water once a month (soak for 1-2 hours, do not wring. • Grease filter paper with indicator should be replaced at least every two months or whenever the colour becomes visible through the holes of the grille. This colour should not be visible through the grille holes when the filter is installed. • The metal grease filter has an unlimited life and should be washed once a month by hand or in a dishwasher (60°C) with appropriate detergents. Whenever cleaning or replacing the grease filters, clean all other exposed parts of the hood. • Carbon filter (“Air recirculation mode”, see following page) The carbon filter cannot be washed or regenerated. Replace the carbon filter (normal usage) every 6 months (Rectangular carbon filter) every 4 months (Circular carbon filter). Replacing bulbs  Pull out the steam deflector (depending on model).  Remove the burnt-out bulb and replace it with a new one of the same wattage. Close the grille, light fixture or metal grease filter. Cleaning the hood Use a soft cloth with methylated spirits or a mild liquid detergent. Failure to observe the instructions for cleaning the appliance and replacing or washing the filters may cause a fire. TROUBLESHOOTING GUIDE Hood does not work: • • • • • • Is the electrical power supply switched on?Are the air outlets blocked? Light does not work: Insufficient suction power: • Does the bulb need to be replaced?Never try to carry out any repair by yourself other than fixing the above-mentioned problems. 34 3gb33015. fm5 Page 35 Thursday, August 23, 2001 12:50 PM AFTER-SALES SERVICE Before calling After-Sales Service  See if you can solve the problem yourself with the help of the “Troubleshooting guide”.  Switch off the hood for a few minutes and re-start it to see if the problem has cleared itself. [. . . ] If the hood does not have a carbon filter, order one and fit it before use. Check that the switch inside the hood (if fitted) is in position “F” Filter; if not, set it to this position. If the plug is provided, close off the upper exhaust hole. Electrical connection Before connecting the hood, make sure the voltage indicated on the rating plate corresponds to the voltage in your home. For GB this appliance is supplied without a plug and is intended for direct connection to fixed wiring in accordance with national wiring regulations. [. . . ]