User manual VIVITAR DVR-510

[. . . ] Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for Class B digital devices, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ] To pause video playback, press the button; to cancel pause, press the button again. This stops playback and returns to the start of the video clip. To playback the video clips on the computer, we recommend using Windows Media Player 9. 0 (WMP 9. 0) or the Software Application we offered. To adjust the sound level, sliding the zoom lever to the T / side will increase the volume, sliding the zoom lever to the W / side will decrease the volume. EN-30 Playing Back Still Images/Video Clips on TV You can also play back your images on a TV screen. Before connecting to any devices, make sure to select NTSC / PAL system to match the video output system of the video equipment you are going to connect to the DVR-510, then turn all devices off. The method of operation is the same as playing back still images and video clips on the DVR-510's LCD screen. TV EN-31 Zoom Playback Images that are being play back can be enlarged. The zoom factor displayed on the screen shows the current magnification ratio. The magnification factors range from 1x to 8x (within 16 stages: 1. 0x, 1. 5x, 2. 0x, 2. 5x, 3. 0x, 3. 5x, 4. 0x, 4. 5x, 5. 0x, 5. 5x, 6. 0x, 6. 5x, 7. 0x, 7. During zoom playback, the outer frame indicates the entire image; while the inner frame indicates the location of the currently enlarged area. Slide the zoom lever upward or downward or press the / buttons to select the area to enlarge. 100-0001 2. 0X Thumbnail Display This function allows you to view 9 thumbnail images on the LCD monitor at the same time, allowing you to quickly search for the image that you want. Follow "Zoom Playback" section steps 1-5 until the thumbnail display is on the screen. Press the / buttons or the zoom lever to select the image/video clip to be displayed at regular size. Press the button. 100-0002 001 / 009 EN-32 Protecting Still Images/Video Clips Set the data to read-only to prevent images from being erased by mistake. Turn on the power by pressing and holding the button to go to [SELECT MODE]. Togge the button. PLAYBACK MENU SLIDE SHOW DELETE FILE DELETE ALL PROTECT 5 SEC ONE FILE ALL FILE EXIT button. Select the still image/video clip that you want to protect with the zoom lever. You may select the still image/ video clip that you want to protect from the thumbnail display. Select [ONE FILE] or [ALL FILE] with the zoom lever, and press the button. To cancel protection, follow the step 5-8 to select [UNLOCK] by pressing the / buttons, and pressthe button. The removal of image protection is executed and the DVR-510 returns to the play mode. ONE FILE LOCK UNLOCK 100-0002 EN-33 Slide Show Display The slide show function enables you to play back still images/video clips automatically in order one image at a time. Select [SLIDE SHOW] with the zoom lever, and press the button. PLAYBACK MENU SLIDE SHOW DELETE FILE DELETE ALL 5 SEC 7 SEC 9 SEC ONE FILE button. PROTECT 6. The video clips displayed the first frame image, and are not played back. To stop slide show, press the button. You can adjust slide show display interval within the range of 5 SEC, 7 SEC, and 9 SEC. EN-34 Deleting Still Images/Video Clips 1. [. . . ] To use the DVR-510 as a PC camera, follow these steps: Step 1: Install the PC camera driver (same as USB driver- this is needed on ACC Windows systems). Yahoo Messenger) Video conferencing (or video editing) software is not included with the DVR-510. This mode is not supported for Mac. General system requirements for videoconference To use the DVR-510 for videoconference, your computer system must include: Microphone Sound card Speakers or headphones Network or Internet connection EN-57 Step 1: Install the PC Camera Driver (same as USB driver- this is needed on ACC Windows systems) The PC-camera driver included on the CD-ROM is exclusively for Windows. After the driver installation is completed, restart your computer. The USB driver that bundled inside the CD-ROM is designed in a form 2 in 1 (USB & PC camera driver). [. . . ]