User manual US ROBOTICS 56K SERIAL CONTROLLER FAXMODEM QUICK INSTALLATION GUIDE

[. . . ] UNITED STATES GOVERNMENT LEGEND If you are a United States government agency, then this documentation and the software described herein are provided to you subject to the following: All technical data and computer software are commercial in nature and developed solely at private expense. 101(a) and as such is provided with only such rights as are provided in U. Technical data is provided with limited rights only as provided in DFAR 252. You agree not to remove or deface any portion of any legend provided on any licensed program or documentation contained in, or delivered to you in conjunction with, this Quick Installation Guide. [. . . ] " NOTE: If you would like to use the voice functionality of this modem, you must install the voice software. This software can be found on the Installation CD-ROM in the Software section. Follow the on-screen instructions to register your modem and to view the warranty information. If the Installation CD-ROM interface does not run automatically, click Windows Start and then click Run. If your CD-ROM drive uses a different letter, type that letter in place of "D. " You can also register your modem online by visiting http://www. The phone cord should be plugged into the jack on the modem and into the wall phone jack. If there was an adapter included with your modem, attach that to the phone cord before inserting it into the wall jack. Refer to the "Verify that the modem is properly installed" section of this guide for possible solutions based on your particular operating system. If Plug and Play fails to find the modem as new hardware, you need to check the following: · confirm that the modem is firmly seated in the PCI slot. The modem should sit evenly in the slot with no part of the gold edge showing. If there was an adapter included with your modem, attach that to the phone cord before inserting it into the wall jack. Possible solution: You may have devices between the modem and the phone jack. There should be no line splitters, fax machines, or other devices between the modem and the wall jack. OFFICE USERS: Possible solution: You may have plugged your modem's phone cord into a digital line. Contact the department responsible for your phone system if you are unsure whether or not your phone line is digital. If your phone system requires dialing "9" to access an outside line, be sure to add "9" before the number you are dialing. VOICE MAIL USERS: Possible solution: If you have voice mail provided by your local phone company, your dial tone may be altered when messages are waiting. My modem sounds like it's trying to connect to another modem but fails. Possible solution: See the electronic help files, which are found within the fax or voice software itself. 92 protocol adds upload speeds of up to 48K, but line conditions may affect the actual speeds during a given connection. Due to unusual telephone line configurations, some users will not be able to take full advantage of V. [. . . ] ROBOTICS shall not be responsible for any software or other CUSTOMER data or information contained in or stored on this product. CUSTOMER OBLIGATIONS CUSTOMER assumes full responsibility that this product meets CUSTOMER specifications and requirements. CUSTOMER is specifically advised to make a backup copy of all software provided with this product. CUSTOMER assumes full responsibility to properly install and configure this product and to ensure proper installation, configuration, operation and compatibility with the operating environment in which this product is to function. [. . . ]