User manual US ROBOTICS 56K INTERNAL VOICE FAXMODEM QUICK INSTALLATION GUIDE FOR WINDOWS REV 1.2

[. . . ] No part of this documentation may be reproduced in any form or by any means or used to make any derivative work (such as a translation, transformation, or adaptation) without written permission from U. Robotics Corporation reserves the right to revise this documentation and to make changes in the products and/or content of this document from time to time without obligation to provide notification of such revision or change. Robotics Corporation provides this documentation without warranty of any kind, either implied or expressed, including, but not limited to, implied warranties of merchantability and fitness for a particular purpose. If there is any software on removable media described in this documentation, it is furnished under a license agreement included with the product as a separate document, in the hard copy documentation, or on the removable media in a directory file named LICENSE. [. . . ] The modem should sit evenly in the slot with no part of the gold edge showing. Check your computer manual to make sure that the PCI slot is configured properly. my modem appeared to install correctly but seems to be performing erratically. Possible solution: Although PCI devices can share IRQs, there are devices on the market that do not share IRQs properly. If the modem has been assigned to an IRQ which shares with one of these devices, the modem may perform erratically. You will see a listing of your system's IRQs and the devices to which they are assigned. If this IRQ is being used by any other devices, it may be causing the modem to work improperly. Either your modem or the device which shares an IRQ with your modem will have to be reassigned to another IRQ in order to resolve your conflict. You may want to try installing the modem in another PCI slot, or refer to the sharing device's documentation for more information about removing, disabling, or relocating it. Possible solution: Your communications software may not function properly if you have more than one version of the software installed, you are using an older version, or you have more than one communications application installed on your system. We highly recommend using the communications software provided with your modem on the Installation CD-ROM. possible solution: Your software's COM port settings may be incorrect. There should be a place in the Setup section of your software that addresses port settings. Make sure the software's port settings match those for your modem. To check which COM port your modem is using, click Windows Start, Settings, and Control Panel. Check your communication software's documentation for instructions about adjusting the port settings in your software. Possible solution: You may not have the correct modem type selected in your software or in Windows. You can also add, remove, or view the properties of modems from this window. The USRobotics modem you have installed should be present in the list of installed modems. If none of the modem descriptions in the list matches your USRobotics modem or no modems are listed, your modem is not installed properly. Possible solution: If you are using software that uses a Windows modem description and you had a previous modem installed, you may need to update your software's setting to reflect the use of the USRobotics V. FOR BOTH DIALING AND ANSWERING PROBLEMS: Possible solution: You may have a bad phone cord connection to your modem. [. . . ] ROBOTICS or its authorised reseller) for any warranty claims to be authorised. ROBOTICS Service Centre within the applicable warranty period to obtain warranty service authorisation. Customer must provide Product Model Number, Product Serial Number and dated Proof of Purchase (copy of original purchase receipt from U. Com CUSTOMER should have the following information / items readily available when contacting U. [. . . ]