User manual UMAX XTREAMER COOLER FITTING INSTRUCTIONS
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual UMAX XTREAMER COOLER. We hope that this UMAX XTREAMER COOLER user guide will be useful to you.
Manual abstract: user guide UMAX XTREAMER COOLERFITTING INSTRUCTIONS
Detailed instructions for use are in the User's Guide.
[. . . ] Page 4
N E A R LY D O N E
Fitting Heatsink
You are now ready to fit the XSC heat sink. You will note that the two rounded corners of the heat sink are not the same, be sure to put the small corner to the top of the Xtreamer, when fitting. [. . . ] The Xtreamer should be used on its stand (vertical) or on its side (horizontal) with the XSC heat sink to the top. If these instructions are followed correctly, then your warranty is still valid.
brought to you by
TRANQUIL PC LIMITED
XTREAMER COOLER
FITTING INSTRUCTIONS
Thank you for your purchase of the
Xtreamer Side Cooler
The cool silent solution
Enjoy your new silent Xtreamer !Tranquil PC Limited
http://www. tranquilpc. co. uk
Tranquil PC Limited
http://www. tranquilpc. co. uk
See Us at
http://www. thextreamer. com
Contact Us at
sales@thextreamer. com
See Us at
http://www. thextreamer. com
Contact Us at
sales@thextreamer. com
Page 2
Page 3
FITTING INSTRUCTIONS
The fitting of the XSC will remove the need for the use of the fan in the Xtreamer. The process of upgrading the cooler is simple, but we do recommend that this short instruction guide is completely read before starting. Once completed, you should turn OFF the fan in the MISCL menu of the Xtreamer setup screen. Also you will want to set the fan to 0/50 if you are running the Xtreamer in NAS mode. To complete the upgrade, you will require all components in this kit and a small flat bladed screwdriver, or kitchen knife (take care, always point any sharp objects away from you when in use).
FITTING INSTRUCTIONS
Removing the SIDE plate and INNER heat sink
(cont. )
Lever back the plastic edge of the Xtreamer case where shown in the figure. Once removed you will see the main chip, with a little white Thermal Interface Material (TIM) on the surface. Please dispose of the original side plate and the inner heat sink responsibly.
Removing the SIDE plate and INNER heat sink
Firstly place your Xtreamer on a flat surface, with the side displaying the A/V connector details facing downwards, as show in the diagram below. Do not remove the plate with the `connector information details' on it. [. . . ] Also remove all surplus sticky tape left on the on the flat plastic surfaces marked B in the diagram. If there are any pieces of tape left over, the new XSC will not fit in place correctly, neither will you be able to practice fit the XSC.
XSC FITTING V1. 0EN
(SEPT 2009)
TRANQUIL PC LIMITED [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE UMAX XTREAMER COOLER
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual UMAX XTREAMER COOLER will begin.