User manual UMAX E3000 QUICK INSTALLATION GUIDE

[. . . ] E3000 Quick Installation Guide STEP 1 Connect the e3000 e3000 Quick In Before you install the Bullet Router, please ask your DSL/Cable Modem Service Provider the following questions: · Do I have a PPPoE (where you must provide a user name and password to get connected), Dynamic IP, PPtP or a Fixed IP Account? [. . . ] Using the cable shipped with the Bullet Router, connect the Bullet Router to the DSL or Cable Modem. Insert one end of the cable to the Bullet Router's connector labeled "WAN" and other end to the DSL/Cable Modem, from where you just remove a cable (Step 3. ) Step 5. Make sure the Bullet Router and the DSL/Cable Modem are on, and then reboot your PC. STEP 2 Configure the e3000 1. Open a browser on your computer and enter http://192. 168. 1. 1 in the Address. 2. Then login the Sharing Router system with no password (by default, there is no password). Basic Setup page is as follows: Press [Setup Wizard] button to setup A. Setup Time Zone 1. Set the time zone for the Sharing Router. 2. Press[Next]button to continue. B. Setup WAN Type Specify the WAN connection type required by your Internet Service Provider. Specify a Cable modem (Dynamic IP), Fixed-IP xDSL, PPPoE xDSL, or PPTP. C. Setup DNS 1. Domain Name Servers are used to map an IP address to the equivalent domain name. [. . . ] (If your WAN IP, Subnet Mask, and Gateway are 0. 0. 0. 0 then see instructions to reset your router. ) [. . . ]