User manual UMAREX COLT 1911 A1

[. . . ] Always be aware that the most important safety aspect of a gun is the shooter. All safeties are mechanical and the shooter is responsible for its proper use. Do not rely on mechanical safeties, think in advance and avoid situations which may lead to an accident. Read the following instruction manual and practice safety handling your gun prior to loading it. See the following sections for information on safe shooting: 1. [. . . ] 4. 3) and close the slide by grasping the front hatching an pushing it closed until it catches. Unloading the pistol - Put the safety on (thumb safety in upper position). - Open the slide by pushing the release lever downward (see illustration 4. 1). - Remove the pellet cylinder and carefully push the pellets out of the cylinder with the cleaning rod. WARNING: Never use a metal object to remove the pellets. - If there is a pellet in the barrel, push it out with the cleaning rod. Safe aiming and shooting WARNING: Always point the muzzle of the gun in a safe direction. Make sure the safety is ON, insert the CO2 cartridge, and load the pistol as described. WARNING: Be very careful where you aim this high effeciency pistol. When you are ready to shoot move the safety to the OFF position (see illustr. Squeeze the trigger with steady pressure until the pistol fires. Double Action/Single Action The pistol will function in either double-action or single-action mode. To fire in double action, apply steady pressure to the trigger until the pistol fires. To fire in single action, first cock the hammer to active single-action mode, then apply steady presure to the trigger until the pistol fires. For rapid-fire shooting we recommend the double-action mode, for more precise aimed shooting we recommend the single-action mode. WARNING: Do not assume that the pistol is unloaded if it fails to fire properly!WARNING: Insufficient CO2 pressure could cause a pellet to lodge in the barrel. See chapter 7, "Use and handling of CO2 cartridges" for further instructions. If a pellet fails to be shot after execution of the operation steps mentioned before this could be due to a feed jam. A feed jam is dangerous. · Put the safety ON covering the RED indicator. · Check the barrel with the cleaning rod to insure that no pellet is lodged in the barrel. · Close and lock the slide without replacing the pellet cylinder. · Aim in a safe direction, turn the safety OFF and shoot the pistol to test the CO2 pressure. · If no CO2 pressure is evident, change the CO2 cartridge. WARNING: Keep hands and face at safe distance from the CO2 cartridge. Use and handling fo CO2 cartridges Certain conditions such as improper storage or very rapid firing can negatively effect the efficient performance or your CO2 pistol. Do not store your pistol in an area of unusually high or low temperature. High temperature can cause increased pressure in the CO2 cartridge leading to a malfuction or permanent damage to the pistol. Low temperatures can reduce pressure in a CO2 cartridge leading to weak shots. The CO2 cartridge can get too hot and explode, damaging the gun and injuring or killing anyone nearby. 1. [. . . ] 4. 5mm(. 177) Air pistole pellets (400 Pack) 4. 1675 Cleaning slugs Targets 17*17cm, for Pellet trap 3. 2071 per 250 pieces Part. 4. 5mm(. 177) Waisted pellets "Diablo", ribbed; Waisted Match pellets "Diablo", smooth; Pointed waisted pellets "Diablo", cooper; Pointed waisted pellets "Diablo", ribbed; Hollow Point Semi Wadcutter; smooth (a 500 pieces) Part. no. : 417. 109 Government belt holster "Quick Defense" Part. no. : 3. 1531 Magnetic Pellet Trap 4 targets are knocked down when a hit is scored. [. . . ]