User manual ULTRAFLEX EFC 4 A

[. . . ] 12) Learn to get to know the parts which make up your dishwasher, you will use it better for it. This is where you will find the description of the controls and the internal parts. 13) This page includes useful tips to help you load your dishwasher correctly and make the most of all the available space. 14) After loading the dishes, you need to select the right wash cycle and measure out the correct dose of detergent and rinse aid. [. . . ] At any time, when the cycle is under way, if you press button "P", the cycle in progress indicator light will light up for a few seconds, followed by the half load indicator light, wherever set. If opening the door soon after the end of the programme, or during it, stand away from the Dishwasher, to avoid possible injury from hot steam. 14 ARISTON DISHWASHER - Instructions for installation and use Only use specific dishwasher detergents. The detergent should be poured into the two containers C and D up to the rim. If you prefer to use the detergent in tablet form, then place one inside the container “D” and close the lid. Detergent and rinse aid B D C D ISHWASHER Useful tips • Use the right amount of detergent: if you use too much, you will not get cleaner dishes, but just more environmental pollution. • Keep your dishwasher detergent and rinse aid in a cool, dry place and away from children. Check whether there is any detergent residue on the edges of the dispenser. The rinse aid container is situated on the inside of the door: It should be filled up when the low rinse aid indicator light "T" flashes. You can adapt the amount of rinse aid used by the dishwasher: regulate the adjuster F which you will find under lid C. If drops of water remain on the dishes or spotting occurs, turn the dosage adjuster to a higher setting. This dishwasher model can be built under a single worktop (please read the relevant instruction sheet). Once the appliance is positioned, adjust the feet by screwing them in or out depending on how high you want it and to level it so that it is horizontal. This electric household appliance should be connected to the water mains using the cold water supply hose provided with the appliance only. Connect the cold water supply hose to a 3/4 gas threaded connection, insert the small filter supplied with the dishwasher and taking care to screw it tightly onto the tap (see Afterhavingboughtormovedyourdishwashertoanotherhome, acorrectinstallation ensuresthatyourdishwasherwilloperatesmoothlyandefficiently. If the water hoses are new or have been out of use for an extended period of time, let the water run to make sure it is clear and free of impurities before making the connection. If this precaution is not taken, the water inlet could get blocked, causing damage to your dishwasher. Your dishwasher can be supplied Your dishwasher has arrived A Fig. 2 with hot water from the mains supply (if you have a central heating system with radiators) at a temperature of no more than 60°C. In this case, the wash cycle time will be about 15 minutes shorter and the wash will be slightly less effective. The connection must be made to hot water supply following the same procedures as those indicated for the cold water connection. Fit the drain pipe into a drain line with a minimum diameter of 4 cm or place it over the sink. [. . . ] Care and maintenance Once in a while, once a month, spend a little time on the filter assembly and the sprayer arms. Cleaning the Water Inlet Filter Periodically clean the water inlet filter (see figure 2 under "Installation") located on the outlet of the water supply tap. After turning off the water tap, unscrew the end of the water supply hose, remove the filter and clean it carefully under running water. Then, return the filter to its place and tighten the water supply hose back into position. [. . . ]